Advertisement
4. CONTENTS
Item
1
Enclosure c/w Ball Bearing Tracks
2
3
4
5
6
7
Bridge Channel (c/w captive nuts)
8
Hex Head Screw M8 x 20 c/w spring & plain washers
9
Drawer Key (record the key code)
(2)
(2)
(1)
Model No API15
5. ASSEMBLY
5.1.
DRAWER REMOVAL FROM ENCLOSURE
5.1.1.
Unlock the drawer if required; open the drawer fully and squarely until it stops (fig.2). Remove the loose components, items 3,4,5
and 6.
5.1.2.
With your thumb, push the plastic catch down one side (fig.3) and with your forefinger up the opposite side. Continue to hold the
catches until fully exposed (fig.4), then release. The drawer can now be fully removed.
5.1.3.
It will be necessary to hold the enclosure steady; unless fitted to the bench; to remove the drawer completely.
5.1.4.
Slide the drawer runners back inside the enclosure after drawer removal.
5.2.
FITTING THE ENCLOSURE TO THE BENCH
5.2.1.
Locate the two bridge channels from beneath the bench at the required centres (fig.1) and (fig.5). As a suggestion only; position the
bridge channels centrally about the bench width for best access.
5.2.2.
Offer the empty drawer enclosure up to the bridge channels aligning slots to the captive nut holes in the bridge channels.
5.2.3.
A second person is required to screw the enclosure to the bridge channels. DO NOT tighten at this stage.
5.2.4.
With all four screws fitted (item 8), with at least three threads engaged on each nut; slide the enclosure to the required position (fig.6)
and tighten all four screws.
5.3.
DRAWER MULLION PARTITION
5.3.1.
Fit (item 3) centrally with self tapping screws (item 5) through the pre-punched holes. Transom plates (item 4) partitioning as required.
5.3.2.
Fit the rubber safety caps (item 6) to all self tapping screw projections, from the underside of the drawer.
5.3.3.
Locate the drawer guides with the enclosure runners and slide the drawer/drawers fully back into the enclosure. Generally the reverse
of removal, without the need to touch the plastic catches. DO NOT force at any stage.
© Jack Sealey Limited
Description
Drawer c/w Runner Tracks
Central Mullion Partition
Transom Partition Plate
Self Tapping Screw
Safety Cap
(9)
1 set per drawer (2 drawers Model No API15)
1 per drawer
4 per drawer
8 per drawer
8 per drawer
(8)
(8)
(2)
Model No API14
Original Language Version
Quantity
1
2
4 sets
2
fig.1
(8)
(8)
(1)
API14, API15 Issue: 4 (H,F) 24/05/23
Advertisement
