Remote Start; Remote Diagnostics; Data Protection - Bosch WAV32M40TH User Manual And Installation Instructions

Press Start / Reload / Pause
3.
a The display shows YES.
Press Start / Reload / Pause
4.
a The network settings are reset.
a If End is shown on the display, the
network settings are reset.
15.6 Remote start
Enable the appliance for remote start
via the Home Connect app.
Note
Remote start is deactivated for safety
reasons in the following
circumstances:
¡ The appliance door is opened.
¡ Start / Reload / Pause
pressed.
¡ Remote Start
¡ The appliance is switched off.
¡ Following a power cut.
Activating remote start
Requirements
¡ The appliance is connected to your
home WiFi network.
¡ The appliance is connected to the
Home Connect app.
¡ A programme is selected.
¡ The appliance door is closed.
Press Remote Start .
▶
a Remote Start
appliance is enabled for remote
start via the Home Connect app.
Deactivating remote start
Press Remote Start .
▶
a Remote Start
15.7 Remote diagnostics
Customer Service can use Remote
Diagnostics to access your appliance
if you contact them, have your appli-
ance connected to the Home Con-
.
.
is
is pressed.
lights up and the
goes out.
nect server and if Remote Dia-
gnostics is available in the country in
which you are using the appliance.
Tip: For further information and de-
tails about the availability of Remote
Diagnostics in your country, please
visit the service/support section of
your local website: www.home-con-
nect.com.
15.8 Data protection
Please see the information on data
protection.
The first time your appliance is
registered on a home network
connected to the Internet, your
appliance will transmit the following
types of data to the Home Connect
server (initial registration):
¡ Unique appliance identification
(consisting of appliance codes as
well as the MAC address of the
Wi-Fi communication module in-
stalled).
¡ Security certificate of the Wi-Fi
communication module (to ensure
a secure data connection).
¡ The current software and hardware
version of your appliance.
¡ Status of any previous reset to
factory settings.
This initial registration prepares the
Home Connect functions for use and
is only required when you want to
use the Home Connect functions for
the first time.
Note: Please note that the
Home Connect functions can only be
utilised with the Home Connect app.
Information on data protection can be
retrieved in the Home Connect app.
Home Connect en
35