iNels RFGB-40 Manual

RFGB-20, RFGB-40,
RFGB-220, RFGB-240
Glass touch controllers
EN EN
RFGB-20
A NEW WAY OF PROGRAMMING!
Characteristics
• The glass touch control is a design component of the RF Control system and is available in an elegant black and white variant.
• Thickness only 8 mm.
• RFGB-20 / RFGB-220: 2 capacitive buttons allow you to control 2 components.
• RFGB-40 / RFGB-240: 4 capacitive buttons allow you to control 4 components.
• When the button is pressed, it sends the set command (ON / OFF, dimming, time off / on, push/ pull). Transmission of the command is indicated by a red LED.
• Ability to set scenes where you control multiple iNELS RF Control devices with one press.
• The rear base allows screwing on the installation box, gluing with double-sided tape or just laying on the table.
• Battery power supply (2x 3 V battery CR 2032 - part of the package) with a lifespan of
approx. 2 years depending on the frequency of use.
• Range up to 200 m (outdoors), in case of insuffi cient signal between the controller and the device use the RFRP-20 signal repeater or devices with the RFIO2 protocol that support this
function.
• Communication frequency with RFIO protocol.
Control options
RF controlers can control:
• switches
RFSA-11B, RFSA-61B, RFSA-62B, RFSA-61M, RFSA-66M, RFSAI-61B, RFSC-11, RFSC-61, RFUS-11, RFUS-61, RFJA-12B
• dimmers
RFDA-73/RGB, RFDA-11B, RFDA-71B, RFDEL-71B, RFDEL-71M, RFDSC-11, RFDSC-71, RFDAC-71B
• lighting
RF-RGB-LED-550, RF-White-LED-675
Radio frequence signal penetration through various construction materials
RFRP-20
RFGB-40
60 - 90 %
brick walls
1 /4
RFGB-220
80 - 95 % 20 - 60 %
wooden structures reinforced
metal partitions
with plaster boards concrete
RFGB-240
0 - 10 % 80- 90 %
common glass