Available Settings; Adjusting The Settings; Frequently Asked Questions - Bosch SHX3AR Series Quick Start And Safety Manual

5 Settings

5.1 Available Settings

Below are some commonly used settings. To see all the settings refer to the full online manual.

5.2 Adjusting the settings

First Steps to adjust any setting:
Open the settings:
1.
Open the door and press the ON/OFF button.
2.
Hold down button > and press START button until the
clean indicator and the sanitized indicator lights flash.
3.
Release buttons.
A. To turn intensive drying on:
1.
Press button < until the display A is lit.
2.
Press Start button to save the setting.
B. To adjust the rinse aid setting:
1.
Keep pressing the button > until the rinse aid refill indica-
tor light flashes for the rinse aid setting.
2.
Displays A and B are lit (Medium setting.)
3.
Press the button < until the desired setting is selected.
Display A = low, A and B = medium, A, B and C = high
and No display lights = off.
4.
Press Start button to save the setting.

6 Frequently Asked Questions

Q: Why is food remaining on dishes after I run the cycle?
• It is possible the dishes do not have adequate clearance between them. Also, be sure nothing is blocking the spray arms and
that the filter is clean. Select the Heavy cleaning cycle.
Q: Why does the cycle run a long time?
• Sensors in the dishwasher automatically increase the cycle time to ensure a good wash when heavy soil is detected.
• Incoming water may not be hot enough and dishwasher has to heat it.
Setting
Rinse Aid
Off/Low/Medium/High
Intensive drying
Off/On
End of cycle tone
Off/Low/Medium/High
Factory setting Description
Medium Setting to adjust the amount of rinse aid
used in each cycle.
Off Setting to increase drying ability for glass-
es or plastic. Increases cycle length and
temperature.
Medium The volume of the tone signalling the end
of cycle.
C. To adjust the end of cycle tone setting:
1.
Keep pressing the button > until rinse aid refill, clean
and sanitized indicators flash.
2.
Displays A and B are lit (= Setting medium, factory
setting.)
3.
Press the button < until the desired setting is selected.
Display A = Setting low, Displays A, B and C = Setting
High and no displays lit is off.
4.
Press Start button to save the setting.