Table of Contents
Advertisement
Error messages
Display
flashes
è
r
E:93
(Displayed at end of
first cycle without hot
water. Not displayed in
subsequent cycles if
hot water is not
available. Reset after
second cycle with hot
water)
E:18
E:32
(alternating display with
END when program is
finished)
E:23
Others
38
Fault
Door not closed properly.
Cold water tap not turned on.
Supply hose for cold water kinked
or pinched closed.
Strainer in water supply hose
clogged.
Cold water pressure too low.
Hot water tap not turned on.
Supply hose for hot water kinked or
pinched closed.
Hot water pressure too low.
Strainer in water supply hose
clogged.
Too much detergent used or non-
HE detergent used.
Å
end of cycle.
Pump is blocked (obstructed).
Not a fault – the unbalanced load
detection system has interrupted
the spin cycle because the laundry
is unevenly distributed.
Water in the base tub, appliance
leaking.
Measure
Check to be sure no laundry is caught in the washer
door. Close the door securely.
Turn on the cold water tap.
Eliminate the cause, replace the hose if damage.
Clean the water inlet strainer.
~ Cleaning the water inlet strainers; Page 32
Eliminate the cause.
Turn on the hot water tap.
Eliminate the cause, replace the hose if damage.
Eliminate the cause.
Connect both supply hoses (hot and cold water) for hot
water appliances.
Use less detergent for future loads. Only use HE
detergents.
displays at
~ Your washing machine is intended for; Page 5
Clean the washer drain hose and/or the drain pipe.
May need to perform pump maintenance to clear
blockage.
~ Cleaning the drain pump; Page 34
Distribute small and large items of laundryevenly in the
drum. If necessary, start an additional spin program.
Turn off the water tap. Call the after-sales service!
Turn off machine, wait 5 seconds and turn on again. If
the display shows again, call customer service.
Advertisement
Table of Contents
