Turning On The Tv For The First Time - Bush CTV401DVD Instruction Manual

Standard features
Simple everyday use
Turning the TV on for the first time
1. Connect one end of the RF coaxial cable to the
aerial socket on the wall and the other end of the
cable to the aerial socket at the rear side of the TV.
• DO NOT connect the TV to the mains supply
until you have completed all the connections.
2. Connect the mains cable to a mains socket (after
completing all other connections).
3.
At this stage the TV will power on in standby mode
(red LED indicator on the front panel). Press the
STANDBY button on the TV or the
remote control to turn on your TV (the red LED will
change to green).
• The STANDBY button is located on the rear
right hand side of the TV.
• Always disconnect the TV from the mains
socket when not in use for a long period of
time.
• The STANDBY button on the rear right hand
side of the TV or the
control is only used for switching the TV into
standby. It does not disconnect the TV from
the mains power. To completely disconnect
the mains power, please remove the mains
cable from the mains socket.
If you require any technical guidance or find that your TV is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
26 Standard features
button on the
button on the remote
4. If this is the first time you are turning on the TV and
there are no programs in the TV memory, the First
Time Installation menu will appear on the screen.
Use the navigation buttons to enter the
settings, select the 'auto tuning' option and press
the OK button to begin the setup process.
OR
RF coaxial cable
(not included)