Safety Instructions And Regulations; Introduction; Safety Indication Symbols - Hitachi EDS500 Series Manual

Safety Instructions and Regulations

2 Safety Instructions and Regulations
2.1

Introduction

Read the following chapter before mounting and commissioning a system or device of the EDS500
series.
2.2

Safety Indication Symbols

The following safety indication symbols are used in this documentation:
Hazardous situation which, if not avoided, will result in death or serious injury of the operating
personnel. The provided information is necessary to know, if you configure a EDS500
series device. The safety indication informs about a restriction etc.
Hazardous situation which, if not avoided, could result in death or serious injury of operating
personnel.
Hazardous situation, which, if not avoided, could result in minor or moderate injury.
Important information not related to personal injury but that should be observed. This symbol
is used to indicate restrictions, prerequisites, and other information that is important for
configuration.
The following safety indication symbols are used on EDS500 series devices:
Symbol
Table 2: Safety indication symbols on EDS500 series devices
1KGT151042 V001 1
Type
Warning Hazardous situation, read documentation (data sheets and operat-
ing instructions)
Advice Protection class II equipment (IEC 61140):
• double insulated and
• with functional earthing.
D A N G E R
WARNING
C A U T I O N
A D V I C E
Level of danger
Introduction
7