Table of Contents
Advertisement
2. INSTALLATION:
DEFINITION
Wood burning stove designed for installation close to a wall, and
which can be moved with no need for additional work. The
connection to the flue pipe is made through stainless steel or
vitreous enamel pipes conforming to standard NFD 35-302. The
connection must be made to an individual flue pipe.
SAFETY CLEARANCE
Comply with the safety clearances indicated between the wall and
the sides or the back of the appliance. If the wall is non-
combustible, then the safety clearance does not apply. Regardless
of the orientation of the stove, there must be a clearance of 2 m
between the glass and the wall or any flammable material.
PREPARATION OF THE STOVE
Unpack the appliance: remove the screws securing it to the pallet.
Install the stove on a floor with sufficient load-bearing capacity. If
the floor cannot support the load, then measures should first be
taken (for example, the installation of a load distribution plate).
Position the stove in its definitive location and level it. For ease of
maintenance, it is recommended to lay tiles or some other type of
covering in the load-bearing area.
MOUNTING THE BAFFLE PLATE
An important element of the appliance's performance, the cast iron
smoke deflector facilitates the collection of soot during sweeping.
On delivery, the deflector is mounted in the device. Before putting
the wood stove into service, assemble and disassemble the
deflector several times to familiarize yourself with this operation.
CHANGING FROM A TOP TO REAR OUTLET
At the time of delivery, the Ø 150 collar is mounted on the top
outlet of the stove. Depending on the flue type, the collar can also
be installed on the rear outlet of the appliance.
To reverse the collar, proceed as follows:
- Unscrew the two screws on the flue collar.
- Release the clips on the plate at the back of the appliance.
- Loosen the rear stop
- Screw the flue collar on to the back of the appliance.
- Screw the stop back onto the top of the appliance.
CONNECTING THE FLUE PIPE
Treat this point of the installation with care and attention in
accordance with DTU 24.1. This appliance must not be connected
to a shared flue system. For ducts that are already in place: get it
cleaned (mechanical chimney brush). Get an authorised stove-
maker to check it for soundness and suitability (stability, air
tightness, compatibility of materials, diameter, etc.). If the flue is
not compatible (old, cracked, considerable blockage): - contact a
specialist so that it can be repaired in order to comply with the
regulations in force.
CONNECTING PIPES
Use pipes made from enamelled T450 stainless steel or 316
stainless steel (available at your stockist), without reducing their
length.
The connection to the flue must be made in the room in which the
appliance is installed. Provide access for chimney sweeping and to
clean the flue pipe. The pipe must not stick out of the flue pipe and
the connections must be removable and airtight.
Maintain a minimum distance of 3 x diameter between the
connecting pipe and the wall.
Advertisement
Table of Contents
