Advertisement
Quick Links
Advertisement
Summary of Contents for Foldcraft ADA
- Page 1 ADA Wall Frame Adjustable Z000000386 Released 11/09/2016 ...
- Page 2 ADA Wall Frame Adjustable Assembly Step 1: Glide Assembly ‐ ADA Wall Style Frame a. Assemble a thread‐in glide into the insert in each of the four (6) legs. (A) (A) (A) (A) (A) Step 2: Frame Assembly a. Using 3/8”‐16 x 3 3/4” hex head cap screw, 3/8‐16 Lock Nut and 3/8” washers, assem‐ ble the seat support leg to the main sup‐ port frame. Note: Use outside holes, no adjustment. b. A ach support leg using 3/8‐16 x 3‐1/2” cap screw bu on head and 3/4‐16 lock nuts. Note: Place bu on head on inside of leg. c. A ach table angle to main support using ...
- Page 3 ADA Wall Frame Adjustable Step 3: Fasten Glides to the Floor a. Rotate glides so that the moun ng hole is poin ng towards the center of the booth. b. With a pencil, mark the hole loca on on the floor using the holes in the glide. c. Turn the glide away 90 degrees from its current posi on to expose the mark on the floor. d. Using a hammer drill and a 1/4” masonry bit, drill a 1 1/4” deep hole on the pencil mark. e. Place a plas c anchor in the hole and then rotate glide back so its hole lines up with the plas c anchor in the floor. ...