Summary of Contents for Foldcraft Plymold Z000000385
Page 1
KD Wall Style Adjustable Z000000385 Released 11/30/16 ...
Page 2
Wall Frame Adjustable Assembly Step 1: Glide Assembly ‐ Adjustable Wall Style Frame a. Assemble a thread‐in glide into the insert in each of the four (4) legs. (A) (A) Step 2: Frame Assembly a. Using 3/8”‐16 x 3 3/4” hex head cap screw, 3/8‐16 lock nut and 3/8” washers, assemble the seat support leg to the main support frame. Note: Start with the Center holes and if needed can open or close the booth opening if needed. b. Repeat step a with the second seat support leg. c. A ach the can lever to the main support frame using 1/4‐20 x 5/8” machine screws on the bo om. Use the 1/4‐20 x 3/4” hex head cap screws with a 1/4‐20 kep nut on the top. ...
Page 3
Wall Frame Adjustable Step 3: Fasten Glides to the Floor a. Rotate glides so that the moun ng hole is poin ng towards the center of the booth. b. With a pencil, mark the hole loca on on the floor using the holes in the glide. c. Turn the glide away 90 degrees from its current posi on to expose the mark on the floor. d. Using a hammer drill and a 1/4” masonry bit, drill a 1 1/4” deep hole on the pencil mark. e. Place a plas c anchor in the hole and then rotate glide back so its hole lines up with the plas c anchor in the floor. ...