Advertisement
| Single Rocker Self-Powered ZigBee
Daintree
®
Commissioning (cont.)
Here is a chart of the ZigBee channels and the
corresponding radio frequencies (in MHz).
Channel ID
Lower
Frequency
11
2404
12
2409
13
2414
14
2419
15*
2424
16
2429
17
2434
18
2439
19
2444
20
2449
21
2454
22
2459
23
2464
24
2469
25
2474
26
2479
*Daintree EZ Connect Preprogrammed to Channel ID 15
Cycle through the sixteen channels
To change the switch's channel, short press the selected
switch button (less than 7 seconds) once after entering
commissioning mode. This will reset the channel used by
the switch to channel 15.
If the switch was already operating on channel 15 (default condition)
then the radio channel will remain unchanged. This ensures that the
switch will always use channel 15 as the starting point for the channel
adjustment.
Short press the selected button (less than 7 seconds)
again to move to the next channel.
For each such button press, the switch transmits on the
next channel. If channel 26 has been reached then channel
15 will be used next.
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject
to change without notice. All values are design or typical values when measured under laboratory
conditions.
Center
Upper
Frequency
Frequency
2405
2406
2410
2411
2415
2516
2420
2421
2425
2426
2430
2431
2435
2436
2440
2441
2445
2446
2450
2451
2455
2456
2460
2461
2465
2466
2479
2471
2475
2476
2480
2481
Switch
®
When the switch is on the correct channel,
the Daintree EZ Connect App will provide a
confirmation indication.
Specifications
ZBT-S1AWH
Daintree EZ Connect Self-Powered Wireless
Rocker Switch
Range
Up to 30 ft or 10 m(typical).
Range can extend up to 100ft or 30 m
(to nearest neighboring
Daintree EZ Connect
device)
Frequency
4°F to +149°F (-20°C to +65°C) Dry location (or
inside Listed non-metallic waterproof enclosure)
Buttons
Green LED (power)
Green LED ( joined network)
Red LED (error state)
Dimensions
Snap-in 1/2" nipple for junction box mount Screw
tab and optional mounting bracket
Operating
-13º to +149º F (-25º to +65º C)
Temperature
Radio
Certified according to FCC, IC and CE regulations
Certifications
Addressing
Factory Set Unique ID
*Switches should be commissioned no more than 10 feet (3 m) from their
intended installation location.
Contains FCC ID: SVZ-PTM215Z
Contains IC: 5713A-PTM215Z
The enclosed device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (i.) this device may not cause
harmful interference and (ii.) this device must accept any interference
received, including interference that may cause undesired operation.
Always follow local electrical codes when installing this device. Installation
should be performed by a qualified electrician.
This device or certain aspects thereof is protected by at least one of the
U.S. or international patent or has at least one such patent application
pending.
CTRL036-Current-Daintree-LED-EZ Connect-Wall-Switch-Spec Sheet
Page 3 of 3
(Rev 06/15/23)
Advertisement
