Advertisement
| Single Rocker Self-Powered ZigBee
Daintree
®
Mounting
Commission (link) the switch to the compatible system
before mounting.
The light switch is compatible with standard decorator style
faceplates.
A faceplate is included.
Surface Mount
For surface mount, attach included backplate to the wall
using screws or adhesive.
Flush Mount
For flush mount, mount the switch without the backplate
into either a standard electrical switch box or a low voltage
mounting bracket using included screws.
Commissioning
PART 1
Activate commissioning (or linking) mode for a system
compatible with the switch.
From the Daintree EZ Connect App, tap to connect to the
room and navigate to the "Switches" tab. Switches should
be commissioned no more than 10 ft (3 m) from where they
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject
to change without notice. All values are design or typical values when measured under laboratory
conditions.
Switch
®
are intended to be installed. Tap the + icon to begin
adding a new switch. Follow the on-screen instructions.
For more information download the
Daintree EZ Connect User Guide.
PART 2
Put the switch into commissioning mode.
Put the switch into commissioning mode.
To enter commissioning mode, start by selecting one
button on the switch. (Use the same button for the
entire sequence. Pressing any other button will exit the
commissioning mode.)
Next, execute the following long-short-long sequence:
1.
Press and hold the selected button for more than 7
seconds before releasing it.
2. Press the selected button quickly (hold for less than 2
seconds).
3. Press and hold the selected button again for more
than 7 seconds before releasing it.
The switch has now entered commissioning mode.
PART 3
Linking the switch to the compatible system.
A radio signal needs to be sent from the switch to the
compatible system on the correct ZigBee channel.
The system uses one of sixteen possible channels,
automatically set by the system. Using the switch, a signal
will be sent on each channel until the channel used by the
compatible system is found.
Upon entering commissioning mode, the switch sends
a signal on the currently selected channel. The signal is
sent on the default channel 15, unless the switch had been
put on another channel previously. (This allows linking
additional devices without changing the currently used
radio channel.)
Zonal Control & Commissioning
Current offers Daintree EZ Connect,
our mobile app based wireless controls
system that provides zonal control and
commissioning of lighting systems. The
app is available for download on the
iOS store.
CTRL036-Current-Daintree-LED-EZ Connect-Wall-Switch-Spec Sheet
Page 2 of 3
(Rev 06/15/23)
Advertisement
