Troubleshooting - BorMann PRO BHL5710 Manual

EN
Storage / care & maintenance
Store this product carefully in a secure, dry place, out of reach of children.
To get the most out of your Telescopic Ladder, and for safety purposes, always clean the Ladder before and after use.
The Telescopic Tubes (5) must be kept clean; dirt, filings, paint, glue etc. must be cleaned away using a clean cloth after use and before the Ladder is closed.
Take care to also clean the rungs.
TIP: For tougher stains, a small amount of non-abrasive cleaner can be added to a soft tissue or cloth. After cleaning, the Telescopic Tubes must be treated
with a silicon spray by opening all sections of the Ladder, spraying and wiping them clean with a paper towel or dry cloth. The Ladder must always be dry.
The end caps of the Ladder must always be sealed to prevent the ingress of dirt and other objects into the body which may cause the Telescopic Tubes to
become damaged.
Any damage to your Telescopic Ladder should be repaired by a qualified person only.
WARNING! Do not use your Ladder if damaged as this poses a severe risk of accident or injury and will void your warranty.

Troubleshooting

Problem
Locking mechanisms will not engage
Telescopic tubes are stiff
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes significantly affect the performance and safety of the
products. The parts described / illustrated in the pages of the manual that you hold in your hands may also concern other models of the manufacturer's product line with similar features and may not be
included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including maintenance and special adjustments, must only be carried out by
technicians of the authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided equipment may cause malfunctions or even serious injury or death. The manufacturer and the importer shall
not be liable for injuries and damages resulting from the use of non-conforming equipment.
7
Solution
The rungs are not properly positioned. Extend to the maximum height for
the rung and attempt to secure again.
The Ladder is dirty/contaminated and must be cleaned as instructed in the
'Care & Maintenance' section above.
WWW.NIKOLAOUTOOLS.GR