Description Of Main Parts; Technical Data - BorMann PRO BHL5710 Manual

EN

Description of main parts

Fitting The Stabiliser Bar
WARNING! The Stabiliser Bar must be fitted before use (Stabilising Bar is only supplied with 3.8m ladder and 3.2m ladder).
Tools required:
1. Flip the Telescopic Ladder vertically
so that the feet are accessible. You will
notice plastic pins in the slot on each
foot. In order to fit the Stabiliser Bar
(7), these pins will need to be snapped.
This can be done easily using a flathead
screwdriver.
4
2. Once the pins have been snapped and
removed, the Stabiliser Bar will fit into
the slots. You will need to line up the
holes on the Stabiliser Bar with the
holes on the legs of the Telescopic
Ladder.
NOTE: You may need a rubber mallet to
carefully tap the Stabiliser Bar into the
slots securely.
WWW.NIKOLAOUTOOLS.GR
1. Top Bar
2. Storage Strap
3. Locking Mechanisms
4. Hand Grips
5. Telescopic Tubes
6. Bottom Rung
7. Stabiliser Bar

Technical Data

Model: BHL5710
Length/steps:
1.9+1.9m/12
Please note that the 3.8m and 3.2m ladder is represented in the images,
the 2.0m and 2.6m ladder does not come with the stabiliser bar.
3. With the Stabiliser Bar slotted onto the feet of the Ladder,
secure into place using the 2 bolts provided.
Tighten the bolts with a wrench to secure.
BHL5720
2.2+2.2m/14