Checking The State Of Charge; During Operation; Starting The Machine; Activating Eco Mode - Toro Power Max e26 Operator's Manual

Checking the State of
Charge
You can view the exact state of charge of each
installed battery; turn the key to the A
position (Figure 16). The position of each set of lights
corresponds to the related battery cavity. If the battery
state of charge is too low and needs to be charged, or
if there is no battery in the corresponding cavity, the
battery presence light does not turn on.
Figure 16
1. State-of-charge lights
2. Battery presence lights

During Operation

Starting the Machine

Note:
Use the battery pack only in temperatures
that are within the appropriate range; refer to
Specifications (page 15).
1. Ensure that the battery pack(s) are installed in
the machine; refer to
(page 15).
2. Insert the electric-start key into the control panel.
3. Turn the key to the A
4. Turn the key to the O
machine (Figure
Note:
If the key is turned from O
the O too quickly, the machine may not start;
N
ensure that the key stops briefly in the middle
A position.
CCESSORY
CCESSORY
3. Key switch in the
A position
CCESSORY
Installing the Battery Pack
position.
CCESSORY
position to turn on the
N
17).
position to
FF
1. Key switch in O
Note:
If the machine is turned on and left idling
or operating without the auger engaged for an
extended period, the motor shutoff timeout will
engage, shutting off the machine. When the
machine shuts off this way it beeps to indicate
that the timeout was engaged.
g348182

Activating ECO Mode

Using ECO mode may extend battery life by reducing
rotor speed; use ECO mode whenever you are
moving light snow, or moving snow a short distance.
Activate ECO mode using the ECO button as shown
in Figure 18.
1. ECO mode button
16
Figure 17
position
N
Figure 18
g347864
g347866