Advertisement
1. Remove the caps from the water heater pipes and
install the isolation valve kit (field-supplied).
2. Install the pipes through the drilled access holes in
the recess box (Figure 14).
3. Connect gas, water and electric service to the water
heater. A waterproof electrical outlet can be fitted
inside.
The installation must conform with local codes or, in
the absence of local codes, with the National Fuel
Gas Code, ANSI Z223.1/NFPA 54, or the Natural Gas
and Propane Installation Code, CSA B149.1. If
installed in a manufactured home, the installation
must conform with the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part
3280 and/or CAN/CSA Z240 MH Series, Mobile
Homes.
The appliance, when installed, must be electrically
grounded in accordance with local codes or, in the
absence of local codes, with the National Electrical
Code, ANSI/NFPA 70, or the Canadian Electrical
Code, CSA C22.1.
Figure 14
1. Seal all access hole penetrations with sealant to
prevent moisture from leaking out of the recess box
(Figure 15).
Figure 15
1. Check for gas and water leaks.
2. Install the recess box front door panel by inserting
the top end first and then pressing the bottom end
into the recess box (Figure 16).
Figure 16
1
2
Advertisement
