Advertisement
STEP 4:
● Place the basket rack on the top plate of the sliding base. Make sure the slides will open
outward from the cabinet.
● Using the included hex wrench, attach the basket rack to the sliding base with the washers
(SS-10.1298) and socket head screws (SS-10.1297).
STEP 5:
● Extend one sliding portion of the basket rack and attach one of the handles (SS-10.1292) to the
sliding portion using the provided handle screw (SS-10.1293).
● Close the sliding portion and attach the handle on the opposite side sliding portion in the same
manner.
STEP 6:
● On each side of the basket rack install a basket clip (SS-10.1294) into each of the bottom slots.
● Insert a basket clip into each bottom slot, then rotate each clip a quarter turn so that the hook is
facing upwards.
● On each side of the basket rack install basket clips in either the top slots, or the middle slots.
INSERTING CLIPS
ROTATING CLIPS
STEP 7:
● For left hand swing doors, exterior baskets are installed on the right side of the basket rack.
● For right hand swing doors, exterior baskets are installed on the left side of the basket rack.
● Install an exterior basket (SS-10.1295) onto the lower basket clips by inserting the top wire in
the basket into each hook. Make sure the clips are located on the exterior basket as shown in the
diagrams.
● Install an exterior basket onto the upper basket clips in the same manner.
● Pull the handle so that the baskets come out of the cabinet and slide the basket rack over to
expose the interior side of the basket rack.
LEFT HAND SWING DOOR
STEP 8:
● Install an interior basket (SS-10.1295) onto the lower basket clips by inserting the top wire in
the basket into each hook. Make sure the clips are located on the interior basket as shown in the
diagram.
● Install an interior basket onto the upper basket clips in the same manner.
LEFT HAND SWING DOOR
CHECK OPERATION
● Verify that the interior baskets will not collide with front interior cabinet wall when moving the
blind corner pullout to fully closed position.
● Verify that the exterior baskets will not collide with any adjacent installed cabinet door, including
pulls or handles when moving the blind corner pullout to fully open position.
● If any collisions occur, remove all baskets from the basket rack. Adjust the location of the basket
rack forward or back as required by loosening the socket head screws and sliding the basket rack.
● Re-tighten the socket head screws, reinstall the baskets, and recheck for collisions.
RIGHT HAND SWING DOOR
RIGHT HAND SWING DOOR
Advertisement
