Klëarvue Cabinetry 478-3923 Instructions

BLIND CORNER PULLOUT
Instructions for SKU 478-3923
KIT INCLUDES:
Sliding Base x1 Basket Rack x1
Socket Head Screw x6 Washer x6
SS-10.1297 SS-10.1298
Handle x2 Handle Screw x2
SS-10.1292 SS-10.1293
Monday – Friday 8-5 Central Time
To find all Klëarvūe Cabinetry® installation instructions and installation videos, visit www.klearvuecabinetry.com
!
IMPORTANT: Please read before you begin the blind corner pullout installation.
NOTE:
● Blind Corner Pullout (478-3923) is intended for use with the Klëarvūe Blind Corner Base
Cabinet (478-0079).
● Check the diagrams below for dimensions of the unit when opened. Make sure no island
cabinets or appliances will intrude in this space.
● Before installing the pullout, install the blind corner cabinet hinges (478-9838 included with
the cabinet box) to the cabinet. Do not install the door front until the blind corner pullout is
completely installed.
BLIND CORNER
BASE CABINET
ADJACENT
BASE CABINET
ILLER
18- 3 / "
4
INTERIOR
BASKET
EXTERIOR
BASKET
1
28- / 4 "
BLIND CORNER
BASE CABINET
FILLER
ADJACENT
BASE CABINET
INTERIOR
BASKET
28- 1 /
4
17- 15 / "
16
Interior Basket x2
SS-10.1296
Mounting Screw x6
SS-10.1299
Hex Wrench x1
QUESTIONS?
Contact Customer Care
1-800-721-4191
RIGHT HAND SWING DOOR
BLIND CORNER
BASE CABINET
ADJACENT
BASE CABINET
18- 3 / "
4
INTERIOR
BASKET
EXTERIOR
BASKET
1
28- / 4 "
LEFT HAND SWING DOOR
ADJACENT ADJACENT
BASE CABINET BASE CABINET
3
18- 3 / " 18- / "
4 4
EXTERIOR EXTERIOR
BASKET BASKET
"
STEP 1:
● Place the drill template (SS-10.1291) on the bottom of the cabinet so that the black arrows
are facing towards the opening and against the side of the cabinet as shown below.
● Using a 1
to not drill completely through the bottom of the cabinet.
● Remove the template from the cabinet.
16- 9 / "
16
Exterior Basket x2
SS-10.1295
Basket Clip x10
SS-10.1294
SS-10.1291
DRILL TEMPLATE
FOR
SKU 478-3923
BLIND CORNER PULLOUT
THIS SIDE UP
FOR RIGHT HAND SWING DOOR FOR LEFT HAND SWING DOOR
THIS EDGE ON CABINET INTERIOR WALL THIS EDGE ON CABINET INTERIOR WALL
CABINET CABINET
THIS EDGE ON CABINET INTERIOR WALL
OPENING OPENING
Drill Template x1
SS-10.1291
STEP 2:
● Remove four socket head screws (SS-10.1217) and washers (SS-10.1298) from the top plate on
the sliding base as shown below.
FILLER
STEP 3:
● Place the sliding base on the bottom of the cabinet. Make sure the four open slots in the top
ADJACENT
BASE CABINET
plate are on the same side as the cabinet opening.
● Attach the sliding base to the cabinet using the six mounting screws (SS-10.1299).
BLIND CORNER
BASE CABINET
FILLER
ADJACENT
BASE CABINET
INTERIOR
BASKET
28- 1 / "
4
/ " drill bit, drill a pilot hole at all six mounting locations on the template. Make sure
16
SIX PILOT HOLES
Open Slots
PILOT HOLES