Table of Contents
Advertisement
Problem
•Blurred lines or images in
text
•Horizontal or vertical lines
are present in the image.
Manual Image Settings
If the automatic picture setting does not provide a picture you are satisfied with, you can perform a manual
picture setting. (VGA [Analog] only)
Note: Turn on the power to the display and wait for about 15 minutes to allow the display to warm up.
1. Press
to open the OSD menu.
2. Use ∧ or ∨ to select "Advanced Settings", and press
3. Use ∧ or ∨ to select "Set the image", and press
access.
4. Use
to select Clock or Phase, and then use
• Clock: (pixel frequency) adjusts the number of pixels that can be scanned in one horizontal scan. If
the frequency is incorrect, vertical bars may appear on the screen and the picture width may be
incorrect.
• Phase: adjusts the phase of the pixel clock signal. When the phase is not adjusted correctly,
horizontal disturbances may appear in the bright picture.
5. When the image no longer looks distorted, press Enter to save the Clock and Phase adjustments.
6. Press
to exit the OSD menu.
Possible Causes
•Image settings are not
optimized
•The system's display property
settings are not optimized.
Recommended Operations
Adjust the system's resolution
setting to the resolution of this
display: 1920x1080 @60 Hz.
Perform the automatic image
setting. If the automatic image
setting does not work, perform
the manual image setting.
When using its resolution,
adjusting the Dots Per Inch (DPI,
dots per inch) setting on the
system can further improve it.
.
to access，Then press "Auto Settings" and then press
or
to adjust the value.
Refer to
"Adjusting the
Display Image" on
pages 2-3
"Select Support
Display Mode" on
pages 2-7
See the Advanced
section of System
Display Properties.
Chapter 3. Reference Information 3-4
Advertisement
Table of Contents
