Table of Contents
Advertisement
This time
Difficult to close
Impossible to close
Open upper housing
during cooking
Promptly start cooking
Fail to cook at the
appointed time
Fail to make appointment
Steam leakage
Please confirm after
finishing cooking.
There are water drops
nearby exhaust nozzle of
steam valve
Water drops on removable cover
plate and inner cooking pot
There are condensed
water dropped from
sealing ring and other
parts after opening
upper housing
Spilling
Thin film generated inside
inner cooking pot
Fail to press button for
operation
The light goes out
It stops halfway
Displayed residual time is
different from the actual
cooking time
24
Investigate the reasons (reference page)
Whether the removable cover plate has been installed well? If the removable cover
plate is not installed, the upper housing cannot be closed to prevent forgetting the
installation of the removable cover plate.
Whether the plug-in part under the removable cover plate is plugged in?
Whether there are foreign matters attached on opening buckle plate?
Whether the removable cover plate is blocked with foreign matters?
Please press the central part on the front side of upper housing until a sound of "clatter".
Whether there are foreign matters attached on opening buckle plate?
Cooking will promptly start for appointment within 1-2 hours.
Whether the a.m. and p.m. are confused? The clock is of 24-hour display mode.
Whether the current time is wrong?
Whether lithium batteries are run down?
If the room temperature and water temperature are lower or water volume is larger,
cooking finishing time may be delayed for about 10 minutes.
Whether inner cooking pot is installed before presetting appointment time?
Whether the appointment is not set or the COOK button is not pressed?
Whether there are foreign matters attached on sealing ring, edge of inner cooking pot
and outer casing cover?
Whether there are foreign matters attached on upper housing and opening buckle plate?
Whether the sealing ring is damaged and whether inner cover or inner cooking pot is deformed?
Whether the removable cover plate is installed?
Steam will be converted to water drops attached after cooling. Not failure.
To prevent rice from getting dry, there may be water drops attached to the removable
cover plate and inner cooking pot, and this is not a failure.
Sometimes, condensed water will drop on outer casing cover and other parts based on the time,
room temperature and other conditions when the upper housing is opened. Please wipe them off.
Condensed water will flow into inner cooking pot (rice), rather than into frame when the cover
is not completely opened or is slightly opened with hands.
In case of cutting off heat preservation or pulling out power plug with rice in, removable cover
plate will cause condensation and there will be much condensed water attached.
Whether there are foreign matters attached on the main temperature controller and outside
inner cooking pot?
Whether there is very little rice or very much water, or rice is washed inadequately?
Is the porridge cooking mode right?
Whether there are foreign matters attached on temperature sensor on the upper housing
and main temperature controller?
Whether there is dirt inside steam valve?
Whether steam valve and removable cover plate is installed well?
Whether the removable cover plate is blocked with foreign matters?
Sticky rice paper-shaped thin film is the dried dissolved sugar (starchiness) in rice, which
is not a fault.
Whether the power plug is plugged in? Whether the inner cooking pot is well
placed?
Pressing OFF/CANCEL button by mistake or long-time power outage will cut off the
power.
Sometimes, there may be difference with the actual cooking time, which is not a fault.
Please refer to the "About display of cooking time" for detsa.il
Advertisement
Table of Contents
