Onward FCA Series Instructions For Installation

INSTRUCTIONS FOR INSTALLATION OF SINGLE OR
DOUBLE CYLINDER DEADBOLTS AND THE REPLACEMENT
OF EXISTING LOCKS
1. MARK DOOR
NOTE : BACKSET ON DOOR FACE
MUST BE SAME AS BACKSET OF YOUR
LOCK.
DRILL HOLES
2.
1" (25 mm) FOR DEADBOLT
3.
INSTALL DEADBOLT
Insert deadbolt in
hole and keep it
parallel to door face.
Mark outline of face
plate and remove
deadbolt.
INSTALL STRIKE
4.
Close door to mark
horizontal center line
of strike.
I N S T A L L A T I O N
a.
Fold and apply template on
high edge of door bevel and
mark center of door edge as
indicated on template at the
desired height from the oor.
b.
Fold and apply template on
high edge of door bevel and
mark center of door edge as
indicated on template at the
desired height from the oor.
Drill holes as marked.
NOTE : DRILL 2-1/8" (54 mm)
HOLE FROM BOTH SIDES OF
DOOR TO AVOID SPLITTING
WOOD.
2-1/8" (54 mm) HOLE FOR
LOCKSET
Chisel 1/8" (3 mm)
Insert deadbolt
deep or until face and tighten
plate ush with screws.
door edge.
Match screw holes on
strike with center lines
on jamb. Mark outline
and chisel 3/32" (2
mm) deep for strike
Measure one half of
door thickness from
door stop and mark
vertical center line of
strike. Drill 1" (25 mm)
hole 1" (25 mm) deep
at intersection of Install strike and
horizontal and vertical tighten screws.
center line of strike.
FCA Series
INSTALL SINGLE CYLINDER
5.
EXTERIOR CYLINDER
EXTERIOR TAIL PIECE
LATCH CRANK
INSIDE TURN UNIT
INSTALLATION SCREW
6 INSTALL DOUBLE CYLINDER
EXTERIOR CYLINDER
LATCH CRANK
EXTERIOR TAIL PIECE
INTERIOR TAIL PIECE
KEY HOLE
1 800 387-6392
TOOLS REQUIRED FOR NEW CONSTRUCTION:
1 philips head screwdriver
1 2-1/8" (54 mm) hole saw
1 1" (25 mm) drill & 1 chisel
TOOLS REQUIRED FOR REPLACEMENT:
1 Philips head screwdriver
a.
Retract deadbolt to unlock
position.
b.
Insert exterior tail piece horizontally
through latch crank.
c.
Press exterior cylinder ush
against door.
d. Install inside turn unit and
tighten installation screws.
KEY HOLE
EXTERIOR CYLINDER
a. Retract deadbolt to unlock
position.
b. Insert exterior tail piece
horizontally through latch
crank.
c. Press exterior cylinder ush
against door.
d.
Insert interior tail piece
vertically through latch
crank.
e. Press interior cylinder ush
against door and tighten
installation screws.
KEY HOLE
EXTERIOR CYLINDER
INTERIOR CYLINDER
INSTALLATION SCREW
800 560-1306 onwardhardware.com