60" [1524]
4" [102]
4" [102]
6-ø1-3/8" [6-ø35]
2-ø1-3/4" [2-ø44]
36" [914]
Installation Manual
• Carefully read the instructions before
starting the installation.
• This vanity should be installed by an
experienced plumber.
• Drain pipe and drain trap are not
supplied. Connect to an existing drain
pipe.
If you are missing any part, please stop
and contact us immediately at:
1-800-986-3460
[1524]
37-1/2"
[953]
4" [102]
4" [102]
Manuel d'installation
• Lire attentivement ces instructions
avant de débuter l'installation.
• Cette vanité devrait être installée par
un plombier professionnel.
• Drain et trappe non fournis.
Connecter à un drain existant.
En cas de pièces manquantes, vous êtes
priés d'arrêter et de nous contacter au:
60"
DIMENSIONS
DIMENSIONS
DIMENSIONES
1-800-986-3460
MELPARK 60
INSTALLATION MANUAL
MANUEL D'INSTALLATION
MANUAL DE INSTALACIÓN
22"
[560]
34-1/2"
[877]
Manual de instalación
• Lea las instrucciones antes de
comenzar la instalación.
• Esta vanidad debe ser instalado por
un experimentado plomero
• Tubo de desagüe y sifón no se
suministran. Conectarse a una
tubería de drenaje.
Si le faltan cualquier parte, por favor
parar y contacto inmediatamente en:
1-800-986-3460
PAGE 1
Need help?
Do you have a question about the MELPARK 60 and is the answer not in the manual?
Questions and answers
I am changing out the hardware on my vanity. I have two pull down drawers where there are no screws for the handle. There are screws, and I tried removing them but it is not for the handle
The manual does not provide specific instructions for installing a handle on the MELPARK 60 vanity drawers. However, in general, if the handle has no visible screws, it may be attached from the inside of the drawer. Check inside the drawer for pre-drilled holes and use the provided screws to secure the handle from the interior. If no holes are present, carefully measure and drill holes before attaching the handle.
This answer is automatically generated