1. Manuals
  2. Brands
  3. OWL Manuals
  4. Test Equipment
  5. 2 Series
  6. Quick reference manual

OWL 2 Series Quick Reference Manual

Hide thumbs
1
2
3
4
5
6

Advertisement

Table of Contents

Quick Reference Guide
Micro OWL 2 Series
Firmware Version 2.03
Micro OWL 2 Series Test Kits
Certification Testing
Quick Reference Guide
For part numbers:
KIT-M2-L2st
KIT-M2-L2sc
KIT-M2-L2fc
OWL
Optical Wavelength Laboratories
Revision 1.1
26009
Optical Wavelength Laboratories (OWL)
N9623 West US Hwy 12
Whitewater, WI 53190
Phone: 262-473-0643
Internet: OWL-INC.COM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 2 Series and is the answer not in the manual?

Questions and answers

Related Manuals for OWL 2 Series

Summary of Contents for OWL 2 Series

  • Page 1 Micro OWL 2 Series Test Kits Certification Testing Quick Reference Guide For part numbers: KIT-M2-L2st KIT-M2-L2sc KIT-M2-L2fc Optical Wavelength Laboratories Quick Reference Guide Revision 1.1 Optical Wavelength Laboratories (OWL) Micro OWL 2 Series 26009 N9623 West US Hwy 12 Firmware Version 2.03...
  • Page 2 GETTING STARTED Thank you for your purchase of this OWL certification test kit. Included in this kit is a Micro OWL 2 optical power meter and a WaveSource multimode fiber optic light source. This quick reference guide will assist you in setting up your test kit for a standards-based certification test.
  • Page 3 Once proper operation has been verified, remove the first patch cable from both units and set it aside. STEP 8 Connect the second singlemode patch cable between the Micro OWL 2 and the Laser OWL as shown in Figure 2.
  • Page 4 Once proper operation has been verified, remove the second patch cable from both units and set it aside. STEP 11 Connect the third singlemode patch cable between the Micro OWL 2 and the Laser OWL as shown in Figure 2. STEP 12 The Micro OWL 2 should read approximately -10.00 dBm.
  • Page 5 For setting a 1550nm reference, repeat steps 25 through 28, except you will select SET REFERENCES WAVELEN REF dBm 1550nm (as shown at right). Also make sure that you set the Laser OWL to 1550nm (the right-hand --------------------- 1310nm -20 00 *1550nm NOT SET indicator LED will be lit).
  • Page 6 STEP 37 If also testing at 1550nm, repeat steps 33 through 36, but this time use the singlemode patch cable attached to the 1550nm port. Also, make sure that you set the Micro OWL 2 and the Laser OWL to 1550nm.

This manual is also suitable for:

Kit-m2-l2stKit-m2-l2scKit-m2-l2fc

Table of Contents