Subscribe to Our Youtube Channel
Related Manuals for WSL TyrePal TC215
Summary of Contents for WSL TyrePal TC215
- Page 1 PAGE 1 505-802-100-1 TC215 MANUAL TC215 TPMS USER MANUAL – INTERNAL & EXTERNAL SENSORS www.tyrepal.co.uk...
- Page 2 PAGE 2 505-802-100-1 TC215 MANUAL MAX= +80°C MIN= -20°C MAX = 99psi / 6.8Bar MAX = 120mph MONITORS LEFT UNDER WINDSCREENS CAN EXPERIENCE EXTREME HEAT, CAN DAMAGE DEVICE DO NOT USE WITH TYRE SEALANT ENSURE SENSOR DOES NOT PROTRUDE BEYOND TYRE SIDEWALL www.tyrepal.co.uk...
- Page 3 PAGE 3 505-802-100-1 TC215 MANUAL NOTE: FOR DISTANCES GREATER THAN 7.0M OUR TCRR-2 SMART SIGNAL REPEATER IS REQUIRED 7.0M max 10 min 10 min SENSORS GO TO SLEEP AFTER 10 MINUTES VEHICLE MOVEMENT. MONITOR GOES TO SLEEP AFTER MINUTES VEHICLE MOVEMENT.
- Page 4 PAGE 4 505-802-100-1 TC215 MANUAL READ INSTRUCTIONS BEFORE INSTALLING THIS KIT DOES NOT REPLACE THE NEED TO CARRY OUT REGULAR CHECKS ON THE CONDITION AND WEAR OF THE TYRES MONITOR SHOULD BE INSIDE VEHICLE WHERE IT DOES NOT INTERFERE WITH DRIVING IT IS YOUR RESPONSIBILITY TO ENSURE THIS KIT IS SUITABLE FOR YOUR PARTICULAR VEHICLE, THAT IT IS WORKING CORRECTLY, AND PROPERLY...
-
Page 5: Monitor Overview
PAGE 5 505-802-100-1 TC215 MANUAL MONITOR OVERVIEW MONITOR BUTTONS, DISPLAY LAYOUT & ICONS ON / OFF SWITCH RED LED ALARM LIGHT AMBIENT LIGHT SENSOR FOR BACKLIGHT CODE LINK TYRE ICON TRACTOR / PRESSURE TEMPERATURE TRAILER DISPLAY DISPLAY VEHICLE °F °C TEMP LOW HIGH FAST... -
Page 6: Charging Port
PAGE 6 505-802-100-1 TC215 MANUAL CHARGING PORT ONLY USE CHARGING LEAD PROVIDED IN KIT. JACK PLUG REQUIRES A FIRM “DOUBLE-PUSH” TO FULLY ENGAGE IN SOCKET 12V – 24V DC www.tyrepal.co.uk... -
Page 7: Battery Installation
PAGE 7 505-802-100-1 TC215 MANUAL INSTALLATION & SET-UP PROCEDURE- EXTERNAL TCSO SENSORS TCSO SENSOR PARTS REQUIRED CR1632 BATTERY BATTERY TOOL LOCK NUT HEX WRENCH RUBBER DUST SHIELD TC215 MONITOR NOTE: SENSOR QUANTITIES WILL VARY DEPENDING ON KIT ORDER BATTERY INSTALLATION - USE BATTERY TOOL TO OPEN AND CLOSE (TIGHTEN) THE SENSOR NOTES: SLIDE BATTERY INTO HOUSING... - Page 8 PAGE 8 505-802-100-1 TC215 MANUAL VALVE DUST CAP REMOVAL CHECK TYRE PRESSURES BEFORE SENSORS ARE INSTALLED MIN. VALVE THREAD LENGTH = 9.0mm NOTE: REPEAT FOR ALL WHEELS REQUIRING SENSORS INSTALL DUST SHIELD & LOCK NUT NOTE: WHEN THE DUST SHIELD IS FITTED FOLD IT BACK ON ITSELF.
- Page 9 PAGE 9 505-802-100-1 TC215 MANUAL PREPARE MONITOR FOR SENSOR REGISTRATION SCREEN WILL SHOW ‘TRACTOR + TRAILER’ ICONS; PSI & degC. NB. ONCE SENSORS ARE SWITCH REGISTERED TYRE ICONS WILL ALSO SHOW WHEN FIRST TURNED ON, BUT NO TYRE DATA SHOWN UNTIL TRAVELLING.
- Page 10 PAGE 10 505-802-100-1 TC215 MANUAL INSTALL & REGISTER SENSOR HOLDING THE MONITOR AWAY (1.5M) FROM THE TYRE, TAKE THE FIRST SENSOR AND SCREW IT ONTO THE VALVE STEM “PSST” = 1-2 SECS NOTE: WHEN THE SENSOR IS SCREWED ON TO THE TYRE VALVE IT DETECTS PRESSURE AND SENDS IT’S UNIQUE ID CODE TO BEEP...
- Page 11 PAGE 11 505-802-100-1 TC215 MANUAL FINISH SENSOR INSTALLATION CHECK THERE ARE NO AIR LEAKS SPRAY INSTALLED SENSOR WITH SOAPY WATER. NO BUBBLES WILL APPEAR IF INSTALLED CORRECTLY LOCK SENSOR USING HEX WRENCH SUPPLIED IN KIT FOLD BACK RUBBER DUST SHIELD SO IT COVERS THE SENSOR INSTALLATION / REGISTRATION COMPLETED...
- Page 12 PAGE 12 505-802-100-1 TC215 MANUAL SET DATA UNITS eg.PSI/Bar; degrees C/F BEEP HOLD PRESS AND “SET” BUTTON FOR 4-5 SECS PRESSURE UNITS BEGIN TO FLASH PRESS “+” OR “–“ BUTTON TO SELECT “PSI” OR “BAR” www.tyrepal.co.uk...
- Page 13 PAGE 13 505-802-100-1 TC215 MANUAL BEEP PRESS “SET” BUTTON FOR 1 SEC TO SELECT PREFERRED PRESSURE UNITS TEMPERATURE UNITS BEGIN TO FLASH PRESS “+” OR “–“ BUTTON TO SELECT “°C” OR “°F” BEEP HOLD PRESS AND THE “SET” BUTTON FOR 4-5 SECS TO REGISTER SELECTED UNITS...
-
Page 14: Set Alarms
PAGE 14 505-802-100-1 TC215 MANUAL SET ALARMS ( for each axle eg.IF VEHICLE’S RECOMMENDED COLD TYRE PRESSURE IS 35psi THEN HIGH=44psi & LOW=30psi ie. +25% & LOW -15% YOUR VEHICLE’S COLD TYRE PRESSURE NOTE: “TRACTOR” UNIT NOTE: “TRAILER” UNIT ALARMS ALARMS HIGH AND LOW PRESSURE HIGH AND LOW PRESSURE... - Page 15 PAGE 15 505-802-100-1 TC215 MANUAL BEEP PRESS AND HOLD “SET” BUTTON FOR 4-5 SECS PRESSURE UNITS BEGIN TO FLASH BEEP - BEEP QUICKLY PRESS “SET” BUTTON TWICE (1 SEC EACH TIME) “HIGH PRESSURE” FLASHES FRONT AXLE FLASHES WANT ADJUST FRONT AXLE HIGH PRESSURE ALARM PRESS THE + OR –...
- Page 16 PAGE 16 505-802-100-1 TC215 MANUAL BEEP ONCE THE FRONT AXLE HIGH PRESSURE ALARM IS SET PRESS THE SET BUTTON FOR 1 SEC. “LOW PRESSURE” FLASHES AND THE FRONT AXLE FLASHES SET LOW PRESSURE ALARM LEVEL 15% BELOW VEHICLES RECOMMENDED TYRE PRESSURE FOR AXLE SELECTED IF YOU WANT TO ADJUST THE...
- Page 17 PAGE 17 505-802-100-1 TC215 MANUAL PROCEDURE TO TEST SET-UP (WHILST VEHICLE IS STATIONARY) REMOVE SENSOR FROM TYRE VALVE. MONITOR WILL ALARM. REPLACE SENSOR TO CANCEL ALARM. MONITOR WILL THEN SHOW TYRE PRESSURE READING. BEEP – BEEP – BEEP… DISPLAY WILL SHOW 0PSI AND AUDIBLE AND VISUAL ALARM WILL BE TRIGGERED.
-
Page 18: Parts Required
PAGE 18 505-802-100-1 TC215 MANUAL INSTALLATION & SET-UP PROCEDURE- INTERNAL TCSI SENSORS NOTE: THE MANUAL DESCRIBES THE INSTALLATION AND SET-UP OF THE INTERNAL SENSORS. IF YOU HAVE A VEHICLE WITH OUR INTERNAL SENSORS PRE-FITTED PLEASE SKIP TO STEP 3 PARTS REQUIRED TCSI SENSOR TC215 MONITOR... - Page 19 PAGE 19 505-802-100-1 TC215 MANUAL CAREFULLY INSTALL THE ATTACH THE THREADED WASHER AND ENSURE IT COLLAR WITH HEXAGON IS SEATED CORRECTLY UPPERMOST, AS SHOWN TEST THE VALVE WITH TORQUE THE THREADED COLLAR TO 6. SOAPY WATER TO ENSURE REFIT THE TYRE & THERE ARE NO AIR INFLATE LEAKS...
- Page 20 PAGE 20 505-802-100-1 TC215 MANUAL BEEP PRESS AND HOLD THE “CODE” BUTTON FOR 4-5 SECS PRESS “+” “-“ BUTTON SELECT WHEEL TO BE MONITORED. “FFF FFF” WILL APPEAR SCREEN. THIS MEANS NO SENSOR IS REGISTERED TO THIS POSITION www.tyrepal.co.uk...
- Page 21 PAGE 21 505-802-100-1 TC215 MANUAL REGISTER SENSORS BEEP WITH THE MONITOR PREPPED AND THE NOTE: IF TWO WHEELS ARE CLOSE TO EACH OTHER ENSURE DISPLAY SHOWING “FFF FFF” THE SENSORS ARE NOT POSITION THE MONITOR WITHIN 50cm ADJACENT. ROTATE ONE WHEEL OR LESS OF THE SENSOR SO THE SENSORS ARE AS FAR APART AS POSSIBLE TO EASE...
- Page 22 PAGE 22 505-802-100-1 TC215 MANUAL BEEP HOLD TO FINISH PRESS AND “CODE” BUTTON SECS. TYRE PRESSURES TEMPERATURES WILL APPEAR ON THE SCREEN. ALARMS MAY SOUND. THESE CAN BE ADJUSTED DURING THE NEXT STEPS SETTING UNITS AND ALARMS FOLLOW STEPS PAGES RESPECTIVELY TO SET THE UNITS AND ALARMS www.tyrepal.co.uk...
-
Page 23: Daily Operation
PAGE 23 505-802-100-1 TC215 MANUAL DAILY OPERATION SWITCHING ON AND SLEEP MODE MONITOR DOES NEED PERMANENT POWER SUPPLY FROM VEHICLE TO FUNCTION. THE INTERNAL BATTERY PROVIDES APPROX. 60 HOURS OF CHARGE. MONITOR SAFELY LEFT SWITCHED ON IF THE VEHICLE IS USED REGULARLY. - Page 24 PAGE 24 505-802-100-1 TC215 MANUAL ALARMS BEEP – BEEP – BEEP… RED ALARM LIGHT FLASHES TYRE ICON FLASHES DEACTIVATE THE AUDIBLE ALARM CORRESPONDING BY PRESSING ANY BUTTON. SENSOR THAT SCREEN WILL STILL FLASH UNTIL DETECTED AN ALARM PRESSURE OR TEMPERATURE IS MONITOR WILL DISPLAY: WITHIN UPPER AND LOWER LIMITS.
- Page 25 PAGE 25 505-802-100-1 TC215 MANUAL BATTERY LEVELS THIS ICON FLASHES THIS ICON INDICATES THE MONITOR’S WHEN THE SENSOR INTERNAL BATTERY STATE OF CHARGE. BATTERY VOLTAGE IS THIS ICON BECOMES ANIMATED DURING LOW. CHARGING. THE CORRESPONDING THE INTERNAL BATTERY IS NOT HARMED TYRE ICON WILL FLASH BY PARTIAL CHARGING AND DOES NOT TO INDICATE WHICH...
- Page 26 PAGE 26 505-802-100-1 TC215 MANUAL LINKING TRAILER PRESS “LINK” “+” BUTTON SIMULTANEOUSLY THE CARAVAN / TRAILER ICON APPEARS ON THE SCREEN REMOVING SENSORS FROM MONITOR BEEP HOLD PRESS “CODE” BUTTON FOR 4-5 SECS www.tyrepal.co.uk...
- Page 27 PAGE 27 505-802-100-1 TC215 MANUAL PRESS “+” OR “–“ TO SELECT WHEEL REQUIRING SENSOR TO BE REMOVED. THE SENSOR SIX DIGIT ID CODE WILL BE DISPLAYED ON THE SCREEN. BIP - BIP TO DE-REGISTER THE SENSOR HOLD PRESS AND THE “SET” BUTTON FOR 4-5 SECS.
-
Page 28: Technical Specification
PAGE 28 505-802-100-1 TC215 MANUAL TECHNICAL SPECIFICATION MONITOR DIMENSIONS 115mm X 73mm X 27mm Weight 132g POWER Powered by internal lithium battery recharged from vehicle power supply. Automatically shuts down when not in use and reactivates as vehicle is used. Charger input 12V to 24V dc. - Page 29 PAGE 29 505-802-100-1 TC215 MANUAL TCSO SENSORS WORKING TEMPERATURE Max 80 °C / Min -20°C STORAGE TEMPERATURE Max 85 °C / Min -20°C PRESSURE RANGE 0 – 99 PSI / 0 – 6.8 Bar PRESSURE ACCURACY ±1.5 PSI (±0.1 Bar) TEMPERATURE ACCURACY ±...
- Page 30 PAGE 30 505-802-100-1 TC215 MANUAL My tyre pressures and temperatures increase when I’m driving? It is completely normal for tyre pressures and temperatures to increase during driving. The vehicle and tyre manufacturers takes this in to account. Our recommended alarm levels allow for this normal pressure and temperature change.
-
Page 31: Managing Tyre Pressures
PAGE 31 505-802-100-1 TC215 MANUAL MANAGING TYRE PRESSURES The recommended tyre pressures are given in the vehicle handbook and are designed to provide the best balance between comfort and fuel economy for your vehicle. The handbook will recommend different tyre pressures depending on how the vehicle is loaded. -
Page 32: Warranty
PAGE 32 505-802-100-1 TC215 MANUAL SPARE PARTS & ACCESORIES www.tyrepal.co.uk AVAILABLE ON-LINE AT DESCRIPTION PART NUMBER TCSO SENSOR WITH CR1632 505-915-107-0 TC215 MONITOR ONLY 505-916-100-0 TCSO BATTERY TOOL 505-918-102-0 CR1632 BATTERY 505-918-105-0 TCSO CAP O-RING SEAL 505-918-107-0 TC215 CHARGING LEAD 505-918-110-0 TC215 MONITOR HOLDER 505-918-111-0...
Need help?
Do you have a question about the TyrePal TC215 and is the answer not in the manual?
Questions and answers