Download Print this page

MaxLite CPL Series Operating Instructions Manual

Led low-profile parking garage & canopy luminaire
Hide thumbs Also See for CPL Series:

Advertisement

Quick Links

Operating Instructions
MaxLite LED Low-Profile Parking Garage & Canopy Luminaire
®
General Safety Information
• To reduce the risk of death, personal injury or property damage from
fire, electric shock, falling parts, cuts/abrasions, and other hazards
read all warnings and instructions included with and on the fixture
box and all fixture labels.
• Before installing, servicing, or performing routine maintenance upon
this equipment, follow these general precautions.
• Commercial installation, service and maintenance of luminaires
should be performed by a qualified licensed electrician.
• DO NOT INSTALL DAMAGED PRODUCT!
• This fixture is intended to be connected to a properly installed and
grounded UL listed junction box.
WARNING:
RISK OF ELECTRICAL SHOCK
• Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• Make all electrical and grounded connections in accordance with the National Electrical Code
and any applicable local code requirements.
• All wiring connections should be capped with UL approved wire connectors.
CAUTION:
RISK OF INJURY
• Wear gloves and safety glasses at all times when removing luminaire from carton, installing, servicing
or performing maintenance.
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as these may be hazardous to children.
CAUTION:
RISK OF FIRE
• Keep combustable and other materials that can burn away from luminaire and lamp/lens
• Do not mount to flammable or combustible surfaces.
• MIN 75°C SUPPLY CONDUCTORS.
Input Rating: 120V-277V 50/60Hz
Operating Temperature: -40°F to 104°F
Models:
CPL Series
© Copyright 2023. MaxLite, Inc. All Rights Reserved.
340 Changebridge Rd, STE 201, Pine Brook, NJ 07058 Tel: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com
Picture is for illustration purposes
only. Your model may vary.
CPL Series
Page: 1
REV: 04/17/23

Advertisement

loading
Need help?

Need help?

Do you have a question about the CPL Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for MaxLite CPL Series

  • Page 1 • MIN 75°C SUPPLY CONDUCTORS. Input Rating: 120V-277V 50/60Hz Operating Temperature: -40°F to 104°F Models: CPL Series © Copyright 2023. MaxLite, Inc. All Rights Reserved. Page: 1 REV: 04/17/23 340 Changebridge Rd, STE 201, Pine Brook, NJ 07058 Tel: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com...
  • Page 2: General Wiring Diagram

    White = Neutral Green = Ground CCT Selectable Models CCT & Wattage Selectable Model © Copyright 2023. MaxLite, Inc. All Rights Reserved. Page: 2 REV: 04/17/23 340 Changebridge Rd, STE 201, Pine Brook, NJ 07058 Tel: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com...
  • Page 3 Close the fixture and secure it with the hex screw loosened in step 1. (Fig. 4) © Copyright 2023. MaxLite, Inc. All Rights Reserved. Page: 3 REV: 04/17/23 340 Changebridge Rd, STE 201, Pine Brook, NJ 07058 Tel: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com...
  • Page 4: Installation

    1. (Fig. 5) © Copyright 2023. MaxLite, Inc. All Rights Reserved. Page: 4 REV: 04/17/23 340 Changebridge Rd, STE 201, Pine Brook, NJ 07058 Tel: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com...
  • Page 5 Screw the pipe into the fixture and feed the wires through it. (Fig. 2) Secure the pipe by tightening the washer nut. (Fig. 2) © Copyright 2023. MaxLite, Inc. All Rights Reserved. Page: 5 REV: 04/17/23 340 Changebridge Rd, STE 201, Pine Brook, NJ 07058 Tel: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com...
  • Page 6 Install the sensor and secure it with the screw included with it. (Fig. 4, Fig. 5) Replace the silicone plug over the screw on the sensor. (Fig. 6) © Copyright 2023. MaxLite, Inc. All Rights Reserved. Page: 6 REV: 04/17/23 340 Changebridge Rd, STE 201, Pine Brook, NJ 07058 Tel: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com...
  • Page 7 ® CCT Selectable Models With EM CCT & Wattage Selectable Model With EM © Copyright 2023. MaxLite, Inc. All Rights Reserved. Page: 7 REV: 04/17/23 340 Changebridge Rd, STE 201, Pine Brook, NJ 07058 Tel: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com...
  • Page 8 Place the EM extension cover and canopy fixture back in place and secure it with the twelve (12) M4 screws removed in step 1 (Fig. 4). © Copyright 2023. MaxLite, Inc. All Rights Reserved. Page: 8 REV: 04/17/23 340 Changebridge Rd, STE 201, Pine Brook, NJ 07058 Tel: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com...
  • Page 9 Attach the Visual Comfort lens to the four (4) corners of the fixture and secure it with the four (4) included screws. 15" Beauty Plate Dimensions (Optional Accessory) © Copyright 2023. MaxLite, Inc. All Rights Reserved. Page: 9 REV: 04/17/23 340 Changebridge Rd, STE 201, Pine Brook, NJ 07058 Tel: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com...
  • Page 10: Warranty Information

    MaxLite or its authorized distributor/dealer (the “Warranty Period”), as follows: If a Product fails to operate during the Warranty Period as a result of defects in materials or workmanship, MaxLite will, at its option, repair it, replace it with the same or like Product.