Safety instructions This manual explains the proper installation and use of your range hood, please read it carefully before using even if you are familiar with the product. The manual should be kept in a safe place for future reference. Never to do: Always to do: This appliance is not intended for use by persons...
Page 3
Safety instructions Never to do: Always to do: This range hood cannot be installed for outdoor use. Attention should be given to ensure that any It is prohibited to fit the range hood over a solid fuel applicable regulations concerning discharge stove of exhaust air are fulfilled.
Operation Mode Your range hood can be operated in two optional modes, choose the mode suitable for your kitchen before installation. Air Exaction For air exaction mode, a ducting kit is required, the air is To outside drawn in and cleaned by the grease filters and directed outside.
Page 9
Installation: Warning: Check that the installation complies with the standards of local building, gas and electrical authorities. Before connecting to the mains supply ensure the mains voltage corresponds to the voltage on the appliance rating plate inside the range hood. When installing the range hood, make sure you adhere to the minimum and maximum distances from the range hood base to the cooktop hob surface.
Page 10
1. Using a spirit level mark a vertical centre line on the wall where the hood is to be positioned, and a horizontal line where the hood base will be. NOTE: The distance from the horizontal line to an electrical cooktop underneath must be minimum of 600mm &...
Page 11
2. Based on above drawing and dimension to drill holes(8mm diameter) and hammer dry wall anchor plugs into holes 3. This step is only for BR6/903CPX, BR6/903CPX-F, BR603SCPX, BR603SCPX-F Use 2pcs ST4x8mm screws to attach lower and upper chimney together, do not fasten screws too much, make sure upper decorative chimney can be telescopically adjusted after assembled.
Page 12
7. Hang on the hood onto the hook of the hood mount bracket, make sure the mount slot on cooker hood completely slide into hooks. *Above photo is just for reference only, actual product could be varies… 8. Fasten the 2pcs anti-tilt ST4x30mm screws onto wall to ensure horizontality of cooker hood. You can find out screw holes inside hood near the motor chamber.
Page 13
11. This step is for BR6/903GC/TX-1, BR6/903GC/TX-1F and BDR6/903TBX, BR6/903TBX-F 11.1 Fasten 2 x ST4x30mm screws onto the wall to fix Lower decorative chimney bracket. 11.2 Attach the upper chimney onto the hook position on lower chimney(both side) Upper decorative chimney (Inner) Lower chimney bracket Lower decorative chimney(Outer) 12.
Start using your range hood BR603GCX-1, BR603GCX-1F, BR903GCX-1, BR903GCX-1F BR603CPX, BR603CPX-F, BR903CPX, BR903CPX-F, CRHC9S01-1, CRHC9S01-F, BR603SCPX, BR603SCPX-F Lamp – Turn on/off light; On/Off – Turn on/off unit Speed –select speed to suit cooking conditions Low – light frying/boiling. Depress this button to enter into low speed and again to turn off motor.
Maintenance and cleaning Caution: spray arm. Washing the filters in a dishwasher may • Before maintenance or cleaning is carried out, the cause discoloration of the aluminum inner mesh over range hood should be disconnected from the main time although it will not affect their performance. power supply.
1.1.1 Australian Consumer Law means the law as set out in Schedule 2 of the Competition and Consumer Act 2010; 1.1.2 Company means GSM Sales Pty Ltd ABN 53 007 682 475 of 142-144 Fullarton Road, Rose Park SA 5067. Telephone 08 8122 2390. Email admin@gsmsales.com.au...
Page 17
GSM Sales Pty Ltd reserves the right to discontinue items, modify designs and change specifications without incurring obligation.
Need help?
Do you have a question about the BR603GCX-1 and is the answer not in the manual?
Questions and answers