Section Two - Uncrating And Installation; Power And Air Connections; Installing In Production Line - Inline PARADIGM 700VS Operation Manual

2.1

POWER AND AIR CONNECTIONS

A grounded electrical male plug is provided with the machine, and is connected to the main electrical enclosure
on the side of the machine. Plug this into any grounded receptacle. On machines with coders or that require air,
an air filter/reservoir with a ¼" male quick disconnect fitting attached, is provided underneath the main
electrical enclosure on machines that require compressed air. You can supply compressed air to the machine by
either a mating quick disconnect on the end of an air hose, or you can permanently pipe air to the machine using
standard pipe and connecting directly into the air filter using threaded pipe connections. If you permanently
pipe air into the system we recommend a cut-off valve be mounted at the machine. Some changeover
adjustments are easier if the operator is able to temporarily turn off the air pressure.
2.2

INSTALLING IN PRODUCTION LINE

Move the machine into its permanent location. Adjust the conveyor height of the machine to match the heights
of the adjoining machines as required. Leveling Pads are provided with the Labeler that allow some vertical
adjustment. If necessary, make spacing blocks to raise the height. Approximately 12 inches of lineal space (as a
SECTION TWO – UNCRATING AND INSTALLATION
System Settings
Coding ON/OFF: Turns the Coding function
on or off
Coding Start: Indicates when Coding is
operational
Coder Delay: This setpoint controls the time
in which the Coder will print
Coder Dwell: This setpoint controls the time
in which the Coder will remain printing
Timeout No Label: This setpoint controls
how long the machine will wait till it shuts
down due to not detecting a label
Timeout No Gap: This setpoint controls how
long the machine will wait until it shuts
down due to not detecting a gap in between
labels
Info: Takes you to the Info Screen
Recipe: Takes you to the Recipe Screen
Main: Takes you to the Main Screen
Support: Takes you to the Support Screen.
This should only be accessed with the
assistance of a technician.