Getting Started; Battery Removal And Installation - VTech Race&Learn DRIVER Instruction Manual

GETTING STARTED

Battery Removal and Installation

1. Make sure the unit is turned Off.
2. Find the battery cover located on the
bottom of the unit, use a screwdriver to
loosen the screw, then open the battery
cover.
3. Remove old batteries by pulling up on one end of each battery.
4. Install 4 new AA (AM-3/LR6) batteries following the diagram inside
the battery box. (For best performance, alkaline batteries or fully
charged Ni- MH rechargeable batteries are recommended.)
5. Replace the battery cover and tighten the screw to secure.
WARNING: Adult assembly required for battery installation. Keep
batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES:
• Remove rechargeable batteries (if removable) from the toy before
charging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.
5