Advertisement
QUICK START GUIDE
To start watching the TV right away you must complete the following steps :
1.
Verify you have received everything
2.
Attach the stand to the TV
3.
Install the batteries to the remote control
4.
Connect power and a cable or antenna to the TV
5.
Turn on your TV and scan for channels
6.
Your TV is ready for viewing
7.
oCOSMO wants to help you save energy! This HDTV meets the ENERGY
STAR® guidelines. The default setting for this HDTV is set to POWER
SAVING mode. You can change this setting by pressing the PICTURE
button on the remote control twice.
1. CE3200 Package Contents
oCOSMO TV Display x 1
TV Stand x 1
Neck x 1
User Manual x 1
Quick Start Guide x 1
Torque Screws x 7 (thick threaded) TYPE1 SCREW
Machined Screws x 2 (fine threaded) TYPE2 SCREW
Screw Driver x 1
Power Cord x 1
Warranty / Registration Card x 1
TV Remote Control (AAA Battery included) x 1
2. Attaching the TV Stand
Obtain 5 torque screws from the package and attach the 5 screws to the bottom of
1.
the base against the neck.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for oCOSMO CE3200
Summary of Contents for oCOSMO CE3200
- Page 1 Turn on your TV and scan for channels Your TV is ready for viewing oCOSMO wants to help you save energy! This HDTV meets the ENERGY STAR® guidelines. The default setting for this HDTV is set to POWER SAVING mode. You can change this setting by pressing the PICTURE button on the remote control twice.
- Page 2 To attach the stand place the display unit flat on a table. Afterwards attach the stand onto the display and screw in the 4 screws to secure the stand. Rear View Mounting Pattern Mounting Specification: 200mm x 200mm using screw size M5. Length of screw should not exceed 9mm. Please Note: The 9mm length of screw refers to how deep the screw can go inside the mounting holes.
- Page 3 3. Installing Batteries to the Remote Please insert two AAA batteries into the remote control. Make sure that you match the (+) and (-) symbols on the batteries with the (+) and (-) symbols inside the battery compartment. Afterwards, re-attach the battery cover. Please note: •...
- Page 4 4. Connecting Your Cables The following picture offers a suggestion for connecting most of your audio video equipment.
- Page 5 Ready to Watch Some TV? Starting up the HDTV Make sure your power cable is connected and the standby red light in the front of the HDTV is lit up. Check all your connection cables off the side or the back of your TV and also your AV devices.
- Page 6 Use the ▲ or ▼ buttons to select AUTO CHANNEL SEARCH and press to scan ENTER for channels. Once the scanning finishes, you can begin to watch HDTV If You’ve Connected set-top boxes to the HDTV… Press the S button on top of the HDTV or the SOURCE button on the remote control and you will see the picture above.
Need help?
Do you have a question about the CE3200 and is the answer not in the manual?
Questions and answers