Table of Contents
Advertisement
Quick Links
To start watching the TV right away you must complete the following steps :
1.
Verify you have received everything
2.
Attach the stand to the TV
3.
Install the batteries to the remote control
4.
Connect power and a cable or antenna to the TV
5.
Turn on your TV and scan for channels
6.
Your TV is ready for viewing
7.
oCOSMO wants to help you save energy! This HDTV meets the ENERGY STAR®
guidelines. The default setting for this HDTV is set to POWER SAVING mode.
You can change this setting by pressing the PICTURE button on the remote
control twice.
1. CE3201 Package Contents
oCOSMO TV Display x 1
TV Stand x 1
User Manual x 1
Quick Start Guide x 1
Plastic Ring x 1
Screws x 4
Screw driver x 1
Warranty / Registration Card x 1
TV Remote Control (AAA Battery included) x 1
2. Attaching the TV Stand
Attach the base to the neck.Obtain 4 screws from the package and attach the 4
1.
screws to the bottom of the base against the neck.
Advertisement
Table of Contents
Related Manuals for oCOSMO CE3201
Summary of Contents for oCOSMO CE3201
- Page 1 Turn on your TV and scan for channels Your TV is ready for viewing oCOSMO wants to help you save energy! This HDTV meets the ENERGY STAR® guidelines. The default setting for this HDTV is set to POWER SAVING mode.
- Page 2 o remove the stand, remove the 5 screws in the circled area and the stand will come off. Rear View Mounting Pattern Mounting Specification: 200mm x 100mm using screw size M6. Length of screw should not exceed 18mm. Please Note: The 18mm length of screw refers to how deep the screw can go inside the mounting holes. When you’re buying screws, you should add the original 18mm to the thickness of your mounting plate in order to get the total screw length.
- Page 3 3. Installing Batteries to the Remote Please insert two AAA batteries into the remote control. Make sure that you match the (+) and (-) symbols on the batteries with the (+) and (-) symbols inside the battery compartment. Afterwards, re-attach the battery cover. Please note: •...
- Page 4 4. Connecting Your Cables The following picture offers a suggestion for connecting most of your audio video equipment.
- Page 5 Ready to Watch Some TV? Starting up the HDTV Make sure your power cable is connected and the standby red light in the front of the HDTV is lit up. Check all your connection cables off the side or the back of your TV and also your AV devices.
- Page 6 Use the ▲ or ▼ buttons to highlight the signal type and press ◄ or ► to select your connection either AIR or CABLE. Use the ▲ or ▼ buttons to select AUTO CHANNEL SEARCH and press to scan ENTER for channels.
Need help?
Do you have a question about the CE3201 and is the answer not in the manual?
Questions and answers