Pulsar PTG1220DBM Operator's Manual
  1. Manuals
  2. Brands
  3. Pulsar Manuals
  4. Lawn Mower
  5. PTG1220DBM
  6. Operator's manual

Pulsar PTG1220DBM Operator's Manual

Gasoline powered lawn mower
Hide thumbs

Advertisement

Table of Contents

Model: PTG1220DBM
Gasoline Powered Lawn Mower
OPERATOR'S MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PTG1220DBM and is the answer not in the manual?

Questions and answers

Curt Gaston
May 18, 2025

Rear grass deflector on PTG1220DBM is broken.

0

Subscribe to Our Youtube Channel

Related Manuals for Pulsar PTG1220DBM

Summary of Contents for Pulsar PTG1220DBM

  • Page 1 Model: PTG1220DBM Gasoline Powered Lawn Mower OPERATOR’S MANUAL...
  • Page 2 You may contact Midland directly at 1-877-528-3772 for product and accessory information and help finding a dealer. To register your product please register online at: www.midlandpowerinc.com Imp- ortant Warning Propsition 65 Warning The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.
  • Page 3 Do not operate this machine while under the influence of alcohol or drugs. gasoline-powered WARNING Uneven terrain could cause a slip or fall resulting in severe injury. Poor footing could cause a slip or fall. help ensure the engine Disconnect the spark plug wire and ground the center electrode to a metal part of the engine.

  • Page 4: Product Specification

    Product Specification Component Specification Rated Speed 2800RPM 150cc Displacement Cutting Width 20” Toolless Height Adjustment Height Adjustment Wheels 7” Front 7” Rear Weight Safety & Instruction Decals Important: Safety & instruction decals are located near Fig. 1 areas of potential DANGER. Replace damaged decals. 2.

  • Page 5: Product Overview

    4. Height Adjustment 5. Handle Loosening Knob Operation Attachments / Accessories A selection of Pulsar approved attachments and accessories are available for use with the machine to enhance and expand its capabilities. Contact your Fig. 8 Authorized Service Center or Distributor.

  • Page 6: Cutting Height Adjustment

    Cutting Height Adjustment WARNING 2. Hold the blade control bar (Fig. 11) against the handle. Adjusting the cutting height may bring you into contact with the moving blade, causing serious injury. · Stop the engine and wait for all the moving parts to stop.

  • Page 7: Operating Tips

    Replace the blade when necessary with a genuine while reducing excess emissions that occur when the Pulsar replacement blade. air/fuel mixture is too rich. This modification need only be done once and should last for the life of the mower.
  • Page 8 Spark Plug Maintenance 1. Once the engine has cooled, remove the spark plug wire. 2. Remove the spark plug using a spark plug wrench. 3. Clean the spark plug with a wire brush (not supplied). 4. Using a feeler gauge set the gap to 0.75mm. 5.

  • Page 9: Replacing The Air Filter

    Replacing the Blade Replacing the Air Filter Service Interval: Yearly Service Interval: 25 Hours Important: You will need a torque wrench to install the blade properly. If you do not have a torque wrench or are 1.Unlock the latch (1) and pull upward to open the air filter uncomfortable performing this procedure, contact an compartment (2).
  • Page 10 WARNING Leave spark plug cable disconnected. deck. Do not turn the lawn mower over, or fuel WARNING and oil will leak, causing a hazardous condition and possible malfunction of the lawn mower STORAGE 1. Loosen handle knobs. Fig. 18 2. Move handle forward and fold it as shown. deck WARNING Do not store the mower in an enclosed area,...

Table of Contents

Save PDF