Advertisement
C.
MOUNT FILTER HEAD
1.
Identify Filter Head and the two Fittings, and note inlet is
1/4" and the outlet is 4 mm.
2.
Apply Teflon Tape
to the threads of each Elbow Fitting.
®
Wrap tape in direction of the threads to assure a tight fit
and avoid small leaks.
3.
Screw the 1/4" Inlet Elbow Fitting into the left side of the
filter head, and hand tighten only.
4.
Screw the 3/8" NPT x 1/4" BSPP adapter onto the outlet
before screwing in the 4 mm Outlet Elbow Fitting into the
right side of the filter head.
5.
Securely mount the filter head on the cabinet wall using
the enclosed mounting screws and washers.
D.
ATTACHINg WATER SUPPLY
6.
Locate and close the cold water Angle Stop Valve. Open
cold water line of faucet to release water pressure.
7.
Unscrew and disconnect the braided tubing on top of the
Angle Stop Valve .
8.
Attach the bottom of Angle Stop Adaptor to the existing
cold water Angle Stop Valve.
9.
Attach the braided tubing to the top of the Angle Stop
Adaptor.
10.
Close side valve on Angle Stop Adaptor and open cold
water Angle Stop Valve to return water service to kitchen
sink. Check for leaks.
11.
Connect 1/4" PF Tubing to water supply
12.
Measure length of tubing needed to connect Angle
Stop Adaptor to Inlet Elbow Fitting on Filter Head. Allow
adequate tubing to avoid sharp turns.
13.
Cut tubing at a 90° angle using a sharp knife.
14.
Insert ends of tubing into quick-connect fittings. Push tube
into fitting and gently pull to confirm a tight fit.
15.
Connect the 4 mm water line from the coffee machine to
the QL3 head with the 4 mm elbow stud on the outlet side
of the QL3
E.
INSTALL AND FLUSH FILTER CARTRIDgE
15.
Lift handle of the built-in shut off in the QL3 head.
16.
Hold head firmly with one hand.
17.
Align cartridge lug with label on filter head.
18.
Insert filter cartridge – Push upwards.
19.
Turn it to the right – About 1⁄4 turn – Until rotation stops.
20.
Open side valve of angle stop adaptor and check for leaks
up to inlet elbow fitting.
21.
Turn water on at supply.
22.
With the filtered water system in the ON position and with
the water retrieval vessel under the tea wand.
23.
Begin rinsing process and press the tea button twice to
remove air.
Be sure to leave the drain water vessel in
position until the cleaning process is completed.
24.
Push and hold the decaffeinated button until "Cleaner
Insert Cleaner" appears in the display.
25.
Push the decaffeinated coffee button again to immediately
start the rinse cycle. If the decaffeinated coffee button is
not pushed again, the cleaning cycle will automatically
start in 20 seconds.
26.
Run the clean cycle a second time after discarding the
rinse fluid from the drain water vessel.
• 2 •
C
2
5
D
7
13
E
15
17
16
18
3
4
6
9
8
15
14
Label
Lug
19
Advertisement
