Maintenance; Cleaning Of Air Filter - Hitachi RAI-35RPA Manual

MAINTENANCE

CAUTION
Cleaning and maintenance must be carried out by qualiÀ ed service personnel.
Before the cleaning, stop operation and disconnect the power supply.
Clean the À lter at least once every one month. This helps save electricity cost.
1.

CLEANING OF AIR FILTER

REMOVAL AND ATTACHMENT OF AIR FILTER
PROCEDURE
1
Remove the À lter from indoor
● Press the mark "PUSH" on the left and
right sides of the suction grille.
● Pull out the À lter from the grille.
2
Remove dust from the À lter using a vacuum
cleaner.
If there is too much dust, use neutral
detergent. After using neutral detergent, wash
with clean water and dry in the shade.
3
Install the À lter. (Set it with "UP SIDE" mark
facing front.)
Slot the À lter to suction grille and close as
original state.
(Press the mark "PUSH" at the left and right
sides of the suction grille to À x it securely.)
Note:
●
This model has an air cleaning À lter. The cooling capacity is slightly weakened and the cooling
speed becomes slower when the air cleaning À lter is used. So, set the fan speed to "HIGH" when
using it in this condition.
CAUTION
● Do not wash with hot water at more than 40°C. The À lter may shrink.
● When washing it, shake off moisture completely and dry it in the shade; do not expose it directly
to the sun. The À lter may shrink.
● Do not operate the air conditioner with the À lter removed. Dust may enter the air conditioner and
cause trouble.
– 9 –