Advertisement
Assembly
Sub-Frame Installation
1. Remove the nuts and bolts (a, Figure 1) from the right and
left mower lift arms (b). Keep the nuts and bolts for Step 2.
b
Figure 1
2. Install the right (Q, Figure 2 ) and left (R) rear hitch
supports between the tractor and the lift arm. Secure with
nuts and bolts from Step 1. On Regent models, secure
the hitch supports with two capscrews (L), and two nuts
(N). Make sure that the hooks (c) of the hitch supports
are installed through the holes of the tractor frame.
Q
Figure 2
a
R
c
3. Install the rear support rod (AA, Figure 3) into the right
and left rear hitch support holes. Secure with cotter pins
(A). Make sure that the cotter pins are on the inside of
the hitch supports.
AA
A
Figure 3
4. Put the sub-frame assembly (BB, Figure 4) underneath
the tractor.
5. Attach the arms of the sub-frame assembly onto the
rear support rod as shown in Figure 4 inset.
BB
Figure 4
A
7
Advertisement
