Advertisement
Operation
DANGER
OPERATING ON SLOPES CAN BE DANGEROUS
Never operate on slopes greater than 17.6% (10°) which
is a rise of 3-1/2 feet (106 cm) vertically in 10 feet (607 cm)
horizontally.
Operate the unit at a slow ground speed when driving onto
slope. Avoid using brakes to control ground speed.
When operating on slopes that are greater than 15 %
(8.5°) but less than 17.6%, use additional wheel weights or
counterweights.
In addition to counterweights, use extra caution when
operating on slopes. Drive UP and DOWN the slope, never
across the face, use caution when changing directions and DO
NOT START OR STOP ON SLOPE.
For additional traction, tire chains and a weight box can be
added. Maximum weight added to tractor should not exceed
35 lbs. per wheel and 100 additional lbs. in weight box.
IMPORTANT
Note: To prevent damage to the unit, raise the blade
BEFORE turning or backing up.
WARNING
Perform the Safety System Interlock test found in your tractor
Operator's Manual. If tractor does not pass the test, do not
operate the tractor. See your authorized dealer. Under no
circumstances should you attempt to defeat the safety system.
Use caution when plowing a snow covered area. Snow can
cover objects such as curbs, drop-offs, and other obstacles.
Be familiar with the area you are plowing.
To prevent an explosion or fire, never store the tractor with fuel
in the tank inside a building where an ignition source is present.
Checks Before Starting
1. Refer to the Maintenance section to perform any
needed service. Also, refer to the tractor Operator's
Manual to perform any required service.
2. Remove all objects from the work area that might
interfere with snow plow activity.
Skid Shoe Adjustment
1. Raise the blade off the ground and block with a piece of
wood.
2. Loosen the bolts and move the skid shoes up or down
to desired height. Tighten the bolts securely.
Engine and Ground Speed Selection
Always run the engine at full throttle.
Set the tractor speed to obtain the needed power to move
the material. Operate at a safe speed to have complete
control of the tractor. Rear wheel weights and chains are
recommended for slippery surfaces.
For additional traction, use a rear weight carrier.
Transporting
For maximum ground clearance, transport to and from
work areas with the blade fully raised and positioned
straight ahead.
Starting and Stopping
1. Start the tractor engine. Set engine throttle to full.
2. Raise the lift attachment and travel to the work site.
3. Set the angle control to the desired blade angle.
4. Lower the attachment lift and begin plowing.
5. Raise the plow before backing up.
6. To stop the tractor, set ground speed to neutral and
set the parking brake. Before leaving the seat, stop the
engine, set the parking brake, remove the key, and wait
for all moving parts to stop.
Blade Angle Adjustment
Note: Change the angle of the blade with the attachment
raised.
1. Raise the attachment lift.
2. Turn the lever counterclockwise to release the angle
mechanism and move the blade left or right. Push the
angle lever forward fully to lock the blade in the left
position. Pull the lever fully back to lock the blade in the
right position. Move the lever slowly over the center to
lock in the centered position.
Snow Plowing Tips
• Determine the best snow removal pattern before
beginning.
• Plan the pattern to avoid pushing snow onto cleared
areas.
• When land contour permits, it is best to travel in the
longest direction to minimize turning.
• In deep or heavy snow, it may be necessary to make
the first pass with the blade partially raised, then repeat
each pass with the blade lowered to clear the material
left on the surface. Also, it may be necessary to clear
less than the full width of the blade or reduce ground
speed.
• Snow tends to freeze into solid banks when plowed off
a driveway or other large area. Plow the snow several
feet past the edge of the drive to allow space for future
plowing to build up.
• If pushing snow past the edges of driveways or
sidewalks, make sure not to tear the grass buried under
the snow. Lift the blade several inches off the ground to
avoid damage to the grass.
• Spinning tires with tire chains can leave unsightly marks
or permanent damage to asphalt or concrete driveways
or sidewalks. Avoid sudden stops or starts.
13
Advertisement
