Table of Contents
Advertisement
Legal notices:
All contents included in this manual are protected by the terms of use and copyrights of Hohner
Elektrotechnik GmbH. Any reproduction, modification, usage or publication in other electronic and printed
media as well as in the internet requires prior written authorization by Hohner Elektrotechnik GmbH.
1. Safety Instructions and Responsibility .......................................... 5
1.1
General Safety Instructions ................................................................... 5
1.2
Use according to the intended purpose ................................................ 5
1.3
Installation ............................................................................................. 6
1.4
Cleaning, Maintenance and Service Notes ............................................ 6
2. Introduction ................................................................................. 8
3. Block diagram .............................................................................. 8
4. Terminal Assignments and Connections ....................................... 9
5. Progarmmable A/B Divider ........................................................ 11
5.1.
Level converter A/B Pulse (A/B Divider: All OFF) ................................. 11
5.2.
Input/Output Mode Converter (A/B Divider: All OFF) ......................... 11
5.3.
Setting the A/B Divider (at A/B Dir to A/B 90°) .................................... 12
5.4.
Setting the A/B divider (for all other modes) ...................................... 13
5.5.
Setting to zero the A/B divider with ZERO_A Signal ............................ 15
5.6.
Informationen over the signal change A/B Dir .................................... 15
6. Programmable Z Divider ............................................................ 16
6.1.
Pegel conversion Z Puls (Z Divider: all OFF) ......................................... 16
6.2.
Setting the Z Divider ............................................................................ 16
6.3.
Location and width of the Z pulse ....................................................... 17
6.4.
Independent Z Divider ......................................................................... 18
6.5.
Automatic generation of a Z pulse ...................................................... 19
6.6.
Reset the Z divider with ZERO_Z Signal ............................................... 19
7. Error Output .............................................................................. 20
8. Dimensions ................................................................................ 21
9. Technical Specifications ............................................................. 22
It210_01a_oi_e.docx / Jan-20
www.hohner-elektrotechnik.de
Table of Contents
Page 2 / 21
4
Advertisement
Table of Contents
