Pairing Mode; Quick Connection - Goldair GPPF340 Operating Instructions Manual

Details for pairing this heater to the Goldair App can be found at the below website link.
Either scan the QR code below or enter the website into your browser.
New Zealand Products
https://www.goldair.co.nz/
goldair-app
To connect to the Goldair app you must ensure that your device is in
pairing mode which is where the Wifi Icon is flashing.
Most products will be in pairing mode after switching the device on
but if it is not:
- Put device on STAND-BY mode (ON at the wall but device is OFF)
- Hold down "SPEED" for around 3 seconds or until the Wifi icon
begins to flash.
- Turn your phone's Bluetooth ON
- Ensure your device is in Pairing Mode (see instructions above)
- Tap the + on the top right corner to navigate to the main device
screen. Tap 'Auto Scan' – your device will appear. Tap the device
and follow the instructions.
- If Quick Connection does not work, follow the manual via the QR
Code above
Pairing APP to Device

Pairing Mode

Quick Connection

Australia Products
https://www.goldair.com.au/
goldair-app