Other Settings - Panasonic SA-HE200 Operating Instructions Manual

Other settings

^ HQ ENHANCED
WAKE
RE-MASTER SOUND MODE SURROUND
MULTI DECODER
8
DOLBY DOLBY DOLBY DTS-ES DTS
DSP DOLBY
NEO:6
SOURCE DIRECT SOUND MODE PRO LOGIC 2 DIGITAL EX DIGITAL PRO LOGIC 2
PHONES
INPUT DVD TAPE - BAND
RDS
A SPEAKERS B MODE 6CH INPUT MONITOR – FM MODE MEMORY PRESET
DISPLAY PTY SEARCH
MODE
A SPEAKERS B
TV VCR
TUNER/BAND MD TAPE
RECEIVER
TOP MENU
ENTER
DISPLAY
SLOW /SEARCH
SKIP
STOP PAUSE
SOUND MODE CHANNEL VOLUME
SUBWOOFER
1 2 3
4 5 6
7 8 9
DIRECT TUNING/
0
10/-/--
DISC
ENHANCED
RE-MASTER / L
SURROUND
DOLBY
SFC EFFECT
PROLOGIC 2
NEO:6 TEST TONE
DIMMER
DIMMER TV VOL
AUDIO GROUP PAGE
DVD
INPUT SELECTOR
VOLUME
INPUT SELECTOR
NEO:6
DOWN UP
VCR 3
2 TUNING 1
PTY SELECTOR
S-VIDEO IN VIDEO IN L AUDIO IN R
DVD
CD
MENU
RETURN
PLAY
MUTING
INPUT
SELECTOR
SOURCE DIRECT
INPUT MODE
DVD 6CH
TIMER
/ R
LEVEL
BALANCE
TV/AV
SETUP
DIMMER –
Dim the display for better viewing
in a darkened room
Press [DIMMER] on the remote control.
Adjusting the brightness of the display
Choose a level between 1 (dim) and 5 (bright).
The factory setting is LEVEL 2.
1 1 Press and hold [A] and [B] at the same time to
enter the setting mode.
2 2 Press [A] to select "DIMMER".
3 3 Turn [INPUT SELECTOR] to select "LEVEL 1",
"LEVEL 2", "LEVEL 3", "LEVEL 4" or "LEVEL 5".
The brightness changes to show the level.
4 4 Press and hold [A] and [B] at the same time to
exit the setting mode.
DR COMP –
Dynamic range compression
Change this setting to listen to software recorded with Dolby Digital
at low volume (such as late at night) and maintain audio clarity. It
reduces the peak level in loud scenes without affecting the sound
field.
OFF: The software is played with the original dynamic range
(factory setting).
STANDARD: The level recommended by the producer of the
software for household viewing.
MAX: The maximum allowable compression (recommended for
night viewing).
1 1 Press and hold [A] and [B] at the same time to
enter the setting mode.
2 2 Press [A] to select "DR COMP".
3 3 Turn [INPUT SELECTOR] to select "OFF",
"STANDARD" or "MAX".
4 4 Press and hold [A] and [B] at the same time to
exit the setting mode.
A/D ATT –
turn the A/D attenuator on if
"OVER" lights frequently when using 2-channel
analogue input
The factory setting is OFF.
1 1 Press and hold [A] and [B] at the same time to
enter the setting mode.
2 2 Press [A] to select "A/D ATT".
3 3 Turn [INPUT SELECTOR] to select "OFF" or
"ON".
4 4 Press and hold [A] and [B] at the same time to
exit the setting mode.
Note
¡The setting affects all 2-channel analogue input.
¡You can raise the volume to a maximum of –10 dB while A/D
ATT is on.
21
RQT6252