I
NSTALLING THE
Connecting to the Console Port
The DB-9 serial port on the switch's front panel is used to connect to the
switch for out-of-band console configuration. The on-board configuration
program can be accessed from a terminal or a PC running a terminal
emulation program. The pin assignments used to connect to the serial port
are provided in the following table.
Wiring Map for Serial Cable
Switch's 9-Pin
Serial Port
2 RXD (receive data)
3 TXD (transmit data)
5 SGND (signal ground) ------------------------------
No other pins are used.
The serial port's configuration requirements are as follows:
• Default Baud rate—9,600 bps
• Character Size—8 Characters
• Parity—None
• Stop bit—One
• Data bits—8
• Flow control—none
3-14
S
WITCH
Figure 3-9 Serial Port (DB-9 DTE) Pin-Out
Table 3-1 Wiring Map for Serial Cable
<----------------------------
----------------------------->
1
5
6
9
Null Modem
PC's 9-Pin
DTE Port
3 TXD (transmit data)
2 RXD (receive data)
5 SGND (signal ground)