Shaw XR11 - Remote Control Starting Manual

Meet Your Device

Turn On Your Device

Your remote arrives with the AA batteries already installed, but not activated. Here is how to power it on for the first time.

1. Pick up your remote and remove the "Pull" tab (on back) by pulling away from the remote. The Status LED will blink green four times as the remote powers up (about 5 seconds).
   
2. Turn on your TV.
3. Turn on your set-top box.
   

Pair Your Unit for Voice Control

Use voice control to search for networks and shows, set DVR recordings, and get recommendations. See Step 5 of this guide for examples.

1. Press and hold the Setup button (about 3 seconds) until the Status LED changes from red to green.
   
2. Press the Shaw button.
3. Follow the on-screen instructions to enter the 3-digit code that appears.
   Once the code is correctly entered, your Shaw remote is paired with the device.
   

Not working? Make sure the battery tab from your remote is removed, your TV is on and you are entering the correct 3-digit code on your TV screen.

Control Your TVs Power and Volume

1. Using the list on the right, find the first 5-digit code for your TV manufacturer.
   
2. Press and hold the Setup button (about 3 seconds) until the Status LED changes from red to green.
   
3. Enter the first 5-digit code for your TV manufacturer. The Status LED should flash green twice.
   
4. Verify that the code was accepted by using your remote to adjust volume and turn the TV on and off.

Not working? Try the second code listed. Still not working? Visit urcsupport.com/shaw for a complete list of codes or use the My Account app for mobile (iOS/Android) or X1.

Have an Audio Receiver or Sound Bar? If you would like to setup your remote to control your audio device or sound bar, visit urcsupport.com/shaw

Test Voice Control

Once your remote is paired with your settop box, you can use voice control.

1. Press and hold the Voice button until you hear the audio tone.
   
2. Speak a voice command to the remote while continuing to hold down the button. Try one of the suggestions below. The Status LED will be solid blue while you speak your command.
3. Release the Voice button when your command is complete. Look at the TV for the results of your voice command.
   

Not working? Make sure you're pressing the Voice button while you speak into the remote, and release it when complete.

Need help?
Visit urcsupport.com/shaw

Keep for future reference, but if you decide to toss, please recycle.

Documents / Resources

References

• Shaw – URC Support

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Shaw XR11 - Remote Control Starting Manual