Carrier SUPRA HE Series Operator's Manual
  1. Manuals
  2. Brands
  3. Carrier Manuals
  4. Air Conditioner
  5. SUPRA HE Series
  6. Operator's manual

Carrier SUPRA HE Series Operator's Manual

Single temperature
Hide thumbs
Table of Contents

Advertisement

Quick Links

SUPRA® HE SERIES
SINGLE TEMPERATURE
OPERATOR'S MANUAL
62-61932-04_Rev04 - JUNE 2023
ENGLISH

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SUPRA HE Series and is the answer not in the manual?

Questions and answers

Related Manuals for Carrier SUPRA HE Series

Summary of Contents for Carrier SUPRA HE Series

  • Page 1 SUPRA® HE SERIES SINGLE TEMPERATURE OPERATOR'S MANUAL ENGLISH 62-61932-04_Rev04 - JUNE 2023...

  • Page 3: Table Of Contents

    SUPRA HE SINGLE TEMPERATURE OPERATOR'S MANUAL TABLE OF CONTENTS 1. Introduction ......................2.

  • Page 4: Introduction

    1. INTRODUCTION 3. SAFETY This guide has been prepared for the operator of Carrier Transicold re- 3.1. WARNING AND PRECAUTION frigeration units. It contains basic instructions for the daily operation of the refrigeration unit as well as safety information, troubleshooting tips, and...

  • Page 5: Warning Stickers Maintenance

    4.1. CAB COMMAND DESCRIPTION • If the refrigeration unit is set in Start/Stop mode • Risk of auto start-up in diesel mode when loss of electrical power (configuration in Carrier Service Center) 3.3. WARNING STICKERS MAINTENANCE 1. Keep the warning pictograms clean and without any obstruction material.

  • Page 6: Lock/Unlock Cab Command

    4.2. LOCK/UNLOCK CAB COMMAND 4.4. STARTING THE UNIT - ROAD OPERATION The lock function allows to block any manipulations from the Cab Command. The user can only start and stop the unit. 1. Place the RUN/STOP switch on the RUN position (l). 2.

  • Page 7: Procedure

    4.5.3. PROCEDURE 4.7. AUTO START/STOP & CONTINUOUS MODES The AUTO START/STOP mode enable the unit to automatically start/restart. • Starts when compartments T° ≠ set point • Stops when compartments T° = set point. AUTO START/STOP mode and CONTINUOUS mode can be combined with the three operating modes: ROAD MODE / CITY SPEED MODE / STANDBY MODE.

  • Page 8: Adjust The Temperature Set Point

    4.9. ADJUST THE TEMPERATURE SET POINT 4.11. UNIT DATA The Unit Data menu allows the user to display the unit's operating data values (hour meters, battery voltage, etc.). Once inside the Unit Data submenus, if no keys are pressed for 5 seconds the display will return to the default display.

  • Page 9: Function

    SYSTEM 4.12. FUNCTION Compressor Discharge Temperature (leaving the com- The Function menu allows the user to set functions such as pressor). PRETRIP, the temperature unit (°C / °F). Compressor Discharge Pressure (leaving the compres- sor). Compressor Suction Pressure (entering the compres- sor).

  • Page 10: Function / Parameter List

    4.12.1. FUNCTION / PARAMETER LIST MODE LSSS Determines the low speed delay adjustment for Selection in bold are factory settings. Start/Stop: Off / 0 to 255 minutes, with 1 minute intervals. TEST PRETRIP Enable or disable PRETRIP: Default: 1 minute. CITY Disable high speed in the speed control overrides: No / Yes.

  • Page 11: Alarm

    • Check if products are loaded at the right This is a non-exhaustive alarm list. ture. temperatures. If you encounter any other alarm, call or go to a CARRIER • Evaporator frosted: launch a manual TRANSICOLD Service Center as soon as possible. defrost.
  • Page 12 POWER ENABLE COIL OPEN FAILED TO START - AUTO MODE 5033 CIRCUIT ENGINE FAILED TO STOP POWER ENABLE CONTACT FAIL 5034 ALARM ENGINE FAILED TO CRANK MCA-IN - LOW SENSOR VOLT- 22801 CHECK COOLANT TEMPERA- TURE MCA-IN - HIGH SENSOR VOLT- 22802 CHECK LOW SPEED RPM MCA-IN - LOST CONFIGU-...

  • Page 13: Maintenance

    All maintenance services must be done by a technician trained on Carrier products respecting all safety and quality standards of • Product stacking is another important factor in protecting the product. Carrier.

  • Page 14: When Loading

    • Select the temperature using the thermostat, according on the goods by the shipper or receiver. More detailed information can be obtained from being transported. your Carrier Transicold dealer. • Check the internal temperature of the goods being loaded (using a probe thermometer).

  • Page 15: Europe Regulation Extract

    Carrier Transicold dealer. in the following way: If you are unable to reach a Service Center, call Carrier Transicold’s Class A: Refrigeration unit furnished with a cooling system whereby a 24Hour Assistance: ONE CALL.
  • Page 16 Middle East and Africa ©2023 Carrier Corporation - Carrier Transicold Europe S.C.S. au cap i tal de 16 090 700 eurosR.C.S. Nanterre 410 041 776 Code APE 4669B - VAT: FR52410041776 - The infor ma tion con tained in this doc u ment is not con trac tu al ly bind ing, and may...

Table of Contents