Check Soundtrap Status; Configure The Deployment - Ocean Instruments SoundTrap ST640 User Manual

2.6 Check SoundTrap Status

Note the 'Status' panel on the right (Figure 4). Carefully review the state of memory and
batteries in the right-hand pane, checking that all batteries show 100% charge and all
memory show 0% used.

2.7 Configure the deployment

•
Select the 'Deploy' tab as shown in figure 4.
•
Configure the deployment parameters as follows:
o The 'Recording Starts' section determines when recording will begin. Recording can
begin immediately on disconnection of the USB cable, at a pre-determined date and
time, or manually using the IR remote control. Note that the remote can always be
used to override the other options.
Figure 5 – Deploy Control