Table of Contents
Advertisement
2.2
JUMPER SETTING OVERVIEW
In order to select the operation modes of your system, configure and set the jumpers on
your SBC to match the need of your application. To set a jumper, a black plastic cap
containing metal contacts is placed over the jumper pins as designated by the required
configuration as listed in this section. A jumper is said to be " on " or " 1-2 " when the
black cap has been placed on two of its pins, as shown in the figure below:
A pair of needle-nose pliers is recommended when working with jumpers. If you have
any doubts about the best hardware configuration for your application, contact your local
sales representative before you make any changes.
standard cable to make most connections.
2.3 INSTALLING THE DIMM MODULE:
A DIMM module simply snaps into a socket on the system board. Pin1 of the DIMM
module must correspond with Pin1 of the socket.
Tab
Pin1
1.Pull the "tabs" which are the ends of the socket to the side.
2.Position the DIMM above the socket with the "notch" in the module aligned with the
"key" on the socket.
3. Seat the module vertically into the socket. Make sure it is completely seated. The
tabs will hold the DIMM in place .
Notch
Key
~5~
JUMPER SETTING AND CONNECTORS
In general, you simply need a
Tab
Advertisement
Table of Contents
