Advertisement
fig.1
fig.4
5. MAINTENANCE
5.1.
The handle can be attached on either side of the nibbler attachment, so that either Die and Punch can be used, therefore doubling the
life of the nibbler attachment.
5.2.
To replace a Die, undo the appropriate Fixing Screw, use the combination tool to undo the Die from the main body of the nibbler
attachment. Fit a new Die and tighten it to the body and tighten the Set-Screw (fig.3).
5.3.
To replace the Punch, firstly remove the Die as above. Take off the Circlip and Cover and undo the Set Screw and Nut. Slide out the
Punch. Fit a new Punch aligning the fixing hole in the Punch with the Sliding Block (fig.4). Re-fit the Set Screw and nut, Cover and
Circlip. Re-fit the Die.
Regularly ensure all screws and parts are tightened.
5.4.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product
becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and
dispose of the product and fluids according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
fig.2
sales@sealey.co.uk
Original Language Version
fig.3
REGISTER YOUR
PURCHASE HERE
www.sealey.co.uk
SNA9821 Issue:1 05/07/23
Advertisement
