Table of Contents
Advertisement
OSD Messages
#
1
Message
Problems with the Projector
#
1
The projector stops responding
to all controls
2
Lamp burns out or makes a
popping sound
Downloaded From projector-manual.com Acer Manuals
All manuals and user guides at all-guides.com
Condition
Fan Fail - the system fan is not working.
Projector Overheated - the projector has exceeded its
recommended operating temperature and must be allowed to
cool down before it may be used.
Replace the lamp - the lamp is about to reach its maximum
lifetime. Prepare to replace it soon.
Lamp is approaching the end of its useful life in full power operation.
Condition
Message Reminder
Fan Fail.
Lamp will automatically turn off soon.
Projector Overheated.
Lamp will automatically turn off soon.
Replacement suggested!
Solution
If possible, turn off the projector, then
unplug the power cord and wait at least 30
seconds before reconnecting power.
When the lamp reaches the end of its useful
life, it will burn out and may make a loud
popping sound. If this happens, the projector
will not turn on until the lamp module has
been replaced. To replace the lamp, follow
the procedures in the "Replacing the Lamp"
section.
29
Advertisement
Table of Contents
