Dosch&Amand DECT Telecare Get Started

COMMISSIONING
charge Device
 fix five self-adhesive bumpons to the charging disc
positioning aids for device on charger
 connect Charging Disk to Power Supply with USB cable
 place Device on the charging disc for about 30 minutes
If Device is correctly placed, you hear a confirmation
tone (delayed in case of deeply discharged battery)
Note: The device is switched on via charging disc !
Smoke Alarm detection will be activated.
COMMISSIONING
register Device at DECT base station
 place Device close to your DECT base
 activate registration mode of base
 press Call Button of Device
"Registration activated"
e.g. Telekom
Speedport
e.g. 1&1
Fritzbox
Note: Device logs on with PIN "0000". If PIN code of Base
is not "0000", you must subscribe Device via PC APP.
Step 1
COMMISSIONING
enter Phone Numbers and Names
Download PC APP to WIN PC
www.pcapp.net
Start installation via the SETUP
After installation, you will get
DECT Telecare icon on
your desktop.
Double-Click on icon and connect
Device to PC with USB cable.
Hint: Plug USB cable OFF and ON
in case Device is not recognized.
Enter all phone contacts and
APPLY your entries page for page.
This will transfer data/audio to the Device.
Step 2
COMMISSIONING
check external phone connection
 call DECT Base with external phone e.g. mobile phone
 Device will ring => OK
Device is operational.
Note: It is best to wear Device under shirt or blouse. The
acoustics are not deteriorated. But it is comfortable to
wear, invisible, protected from dirt and finally best
position for Fall Detection algorithm of Device.
Note: Please note
commissioning Device without PC APP
(only emergency transmitter, no phone book)
Step 4
Step 3
adjacent instructions for
Info to Registration to DECT Base
Registration fails
(Registration = Subscription)
announcements
Note: Pay attention to
wrong PIN
» « The base station does not use 0000
help: => register with help of PC APP
not in Registration mode
» «
help: => activate Registration Mode (again)
no base found
» « base station is switched off
or out of range
help: => switch on Base, place Device closer
check base
» « too many DECT phones are registered
help: => De-registrate at least 1 DECT phone
COMMISSIONING
use as Emergency Call only
Prerequisite: Step 3 is completed:
Device is registered to your DECT station
Device rings when a call is received
Note: Fall detection and smoke alarm detection are
already configured ex works
Set emergency number without PC APP:
The missing emergency number can be set by calling the
device. Accept call and you will be asked to save this
telephone number. The telephone number has now
been saved as emergency number, for
1. manual emergency call, press call button (2sec)
2. automatic emergency call in case of fall detection
3. automatic emergency call in case of smoke alarm
Note: You can change or amend emergency calls later
via PC APP (see Commissioning Step 4)
from Device
without PC APP