Boss V-Wah PW-10 Owner's Manual page 7

4. Pedal
Controls the wah effect.
Step down hard on the pedal, and the toe
switch is activated. Rock the pedal back, then
put firm pressure on the heel to activate the
heel switch.
You can change the pedal torque (the force or
load required to pivot the pedal) by adjusting
the screw located on the right side of the unit
(shown by arrow).
* Use a hexagon socket screw key (5 mm) to
adjust the screw.
* Take care not to overtighten the screw; doing
so may damage the unit.
When you operate the pedal, please be
careful not to get your fingers pinched be-
tween the movable part and the panel. In
households with small children, an adult
should provide supervision until the child
is capable of following all the rules essen-
tial for the safe operation of the unit.
Part Names and Functions
5. Toe Switch
Switches on/off the effect selected with the
TYPE knob.
* The distortion remains turned on.
6. Heel Switch
This switches between "MANUAL" and
"MEMORY (1–3)."
When the heel switch is pressed continuously
for two or more seconds, the ON/OFF indica-
tor flashes, and the pedal switches to bypass
mode (operating the pedal or adjusting the
knobs switches the pedal out of bypass).
When bypass is in effect, guitar sounds input
at the INPUT jack are output from the OUT-
PUT jack without being altered.
* You can change the way the heel switch
changes between "MANUAL" and
"MEMORY (1–3)." For more on how to
change this setting, refer to "Changing the
Operation of the heel switch" (p. 20).
7