Installation - Glacier bay HD67735-0008D2 Installation And Care Manual

Installation

1
Installing the connector
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Clean the mounting surface.
□
Wrap thread sealant tape (not included) around
the stub out pipe threads (1) extending from the
wall in a counterclockwise direction, as shown.
□
Place the ange (C) onto the connector (D) and
wrench-tighten the connector (D) onto the stub
out pipes (1) extending from the wall (do not
over tighten).
C
D
3
Installing the faucet assembly
□
Insert the washers (E) into the faucet body (A),
and then wrench-tighten the faucet body (A)
to the connectors (D).
2
□
1
A
4
Installing the spout assembly
Thread the spout assembly (B) onto the faucet
body (A) and hand tighten the spout assembly (B)
to ensure a complete seal.
D
E
B
A