Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for FVG Romi Start-UP
Summary of Contents for FVG Romi Start-UP
- Page 1 Römi Start-UP Instructions for Use ® Competence in fi lms Version 08/2022...
-
Page 2: Table Of Contents
FVG Folien-Vertriebs GmbH Contents Ebernhahner Str. 22 | D-56428 Dernbach / Germany Phone: +49 (0) 26 02 / 92 64 0 | Fax: +49 (0) 26 02 / 92 64 24 info@fvg-folien.de Introduction Page w w w. f v g- fol i en . de... - Page 3 WARNINGS Required tools (not supplied) • DANGER TO LIFE AND ACCIDENT RISK FOR CHILDREN AND INFANTS! • Protective/work gloves • Scissors • RISK OF SUFFOCATION! Never allow children to play with the packaging material or film • Sledgehammer • Trestle unsupervised! • RISK OF SWALLOWING and SUFFOCATION! Keep children and infants away from the • Pipe wrench •...
- Page 4 Römi®Start-Up parts list Römi®Start-Up individual push-fi t tubes Quantity for each standard version in the relevant length Description Römi 6 Römi 8 Römi 10 Römi 12 Römi 14 + 2 m Part A1 5 (6) 5 (6) 5 (6) 5 (6) 5 (6) 1.50 m, 4 x wind brace counterpart and 1 x (2) door ridge...
- Page 5 Römi®Start-Up parts overview Römi®Start-Up push-fi t tubes Corner connector for door Door bolt 4 door poles Manual soil drill adapter Door hinge 32 mm bolt clamps 25 mm bolt clamps (see engraving) 27 mm & 32 mm Omega- Rounded head Ground omega-shaped clip shaped clip...
- Page 6 >2.00m and the arch spacing is For further information and queries contact us at +49 (0) 2602 9264-0 stated as 2m. or info@fvg-folien.de. When screwing the anchors into place, ensure that The sketch shows the soil conditions provide the necessary secure hold.
- Page 7 Römi®Start-Up Arch with door and wind brace End arch, Römi®Start-Up with purlin version Centre arch For 2-door versions continue as described on page 12. • Same as 2nd and penultimate arch, except without bolt clamps for wind brace End arch of 1-door version = 7 bolt clamps Arch 1 = (with door) = 7 bolt clamps Penultimate arch = 8 bolt clamps Arch 2 = 8 bolt clamps First thread on the bolt clamps then connect the poles! Arch 3 and subsequent/centre arches until penultimate arch...
- Page 8 Step Step Assemble the arches and affi x the bolt clamps in place Mounting the wind brace • First open just one bundle of arch parts because the individual parts were bent together. For that reason, only these parts can be connected to form a WARNING! straight arch.
- Page 9 Step Door system Preparing and mounting the film • Put the door ridge (A1/H) in the space between the bolt clamps on the first arch (see p. 12) and, at the WARNING! same time, place the flat side of doorpost Part B on the outside of the bolt clamp, then lightly tighten the RISK OF CUTS and INJURIES! Always wear protective / work gloves when handling the pro- duct.
- Page 10 To prevent mechanical damage only use the supplied omega-shaped clips. The omega-shaped clips may not be placed directly onto the greenhouse fi lm. Cut a piece of the protection fi lm off the roll (double the clip width) and place it under each clip before affi xing it in place.
- Page 11 Schritt Step Tensioning with tension rope Fertigstellen der Tür mit Folie General information: Surplus, protruding fi lm has to be turned inwards. VORSICHT! RISK of CUTS and INJURIES! Always wear protective/work gloves when handling the pro- 2. Unwind the rope and throw duct.
- Page 12 Accessories Information about the use of Römi®Start-Up Shading net Hang the shading net over the tunnel and affix it with the tension rope (in the • For efficient ventilation of the greenhouse you can gather up the film on same way that you affixed the greenhouse film) to protect your plants from the sides.
-
Page 13: Hazard And Safety Information
Always repair • Loosen and remove the tension ropes. • Then loosen and remove the omega-shaped clips with the supplied pliers. tears immediately with FVG repair tape. Step Film Fold up the film on the long sides up to top of the arch. -
Page 14: Warranty And Liability
Check that the arch elements are still correctly positioned on the ground an- chors. Otherwise the other arches might fall over when you continue dismantling FVG accepts no liability for damages caused by incorrect assembly or poor the frame. care. These instructions for use have been compiled to the best of our knowl- Start to remove the wind brace between the first and second arch, and the edge and belief. -
Page 15: Fvg Folien-Vertriebs Gmbh Ebernhahner Str. 22 | D-56428 Dernbach / Germany
Close collaboration with institutes and universities Laboratory For further information about products contact: FVG Folien-Vertriebs GmbH Ebernhahner Str. 22 | D-56428 Dernbach / Germany Phone: +49 (0) 26 02 / 92 64 0 | Fax: +49 (0) 26 02 / 92 64 24 info@fvg-folien.de...
Need help?
Do you have a question about the Romi Start-UP and is the answer not in the manual?
Questions and answers