Rockford Fosgate M162C Installation And Operation Manual page 7

NOTE:When NOT bi-amping the crossover, connect to the W inputs only.The jumpers must be
in the "Normal" position.
Connect
from Source
or Amplifier
Installing Speakers
1. Cut the proper size hole for the speaker.
NOTE: See Specifications for proper hole size.
2. Place the speaker into the mounting hole and mark the location of the screw mounting holes.
3. Remove the speaker. Drill the holes for the screws using a 1/8" drill bit.
4. Route the wire through the mounting hole cut-out.
5. Attach the wires. Observe proper speaker polarity.
6. Place the speaker into the hole and screw the speaker into place.
Mounting Hole,
Cut-Out
Example of speaker installation
Speaker
I
NSTALLATION
Screw
7